Frictional Energy Dissipation in a Rough Hertzian Contact

نویسندگان

  • D. Dini
  • D. A. Hills
چکیده

The interfacial contact pressure and shear traction distributions are found for a sphere pressed onto an elastically similar half-space whose surface is populated by a uniform array of spherical asperities, when the normal load is constant and an oscillatory shear, less than that needed to cause sliding, is imposed. Details of the load history suffered by asperities in an outer sliding annulus and an inner disk, where they experience partial slip, are found, together with the effects of the roughness on the overall tangential compliance and the frictional energy losses. It is shown that for the example combination of parameters chosen, under light shear loads, the rough contact absorbs less energy than a smooth one subject to the same loading history, but that for larger shearing forces the reverse is true. DOI: 10.1115/1.3063697

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Frictional systems under periodic loads — History-dependence, non-uniqueness and energy dissipation

Nominally static contacts such as bolted or shrink-fit joints typically experience regions of microslip when subjected to oscillatory loading. This results in energy dissipation, reflected as apparent hysteretic damping of the system, and also may cause the initiation of fretting fatigue cracks. Early theoretical studies of the Hertzian contact problem by Cattaneo and Mindlin were confirmed exp...

متن کامل

Frictional energy dissipation in contact of nominally flat rough surfaces under harmonically varying loads

If the nominal contact tractions at an interface are everywhere below the Coulomb friction limit throughout a cycle of oscillatory loading, the introduction of surface roughness will generally cause local microslip between the contacting asperities and hence some frictional dissipation. This dissipation is important both as a source of structural damping and as an indicator of potential frettin...

متن کامل

Measurement and Modeling of Normal Contact Stiffness and Contact Damping at the Meso Scale

Modeling of contact interfaces that inherently include roughness such as joints, clamping devices, and robotic contacts, is very important in many engineering applications. Accurate modeling of such devices requires knowledge of contact parameters such as contact stiffness and contact damping, which are not readily available. In this paper, an experimental method based on contact resonance is d...

متن کامل

Effect of phase on the frictional dissipation in systems subjected to harmonically varying loads

When contacting elastic systems are subjected to periodic loading, frictional slip occurs resulting in energy dissipation. Here we investigate the effect of the relative phase of harmonically varying tangential and normal loads on the frictional dissipation in a very simple uncoupled frictional system. We demonstrate that this effect is substantial when the system experiences periods of separat...

متن کامل

1 5 O ct 2 00 2 Elasticity and onset of frictional dissipation at a non - sliding multicontact interface

We measure the elastic and dissipative responses of a multicontact interface, formed between the rough surfaces of two contacting macroscopic solids, submitted to a biased oscillating shear force. We evidence that beyond a linear viscoelastic regime, observed at low shear amplitude, the interface response exhibits a dissipative component which corresponds to the onset of frictional dissipation....

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2009