Improvement of Source Power Factor for Non- Linear Load Using Boost Converters
نویسنده
چکیده
Abstract: With rapid development in power semiconductor devices, the usage of power electronic systems has expanded to new and wide application range that include residential, commercial, aerospace and many others. Power electronic interfaces e.g. switch mode power supplies (SMPS) have proved to be superior over traditional linear power supplies. However, their non-linear behavior puts a question mark on their high efficiency. The current drawn by the SMPSs from the line is distorted resulting in low power factor.
منابع مشابه
A Novel Method for Modeling and Simulation of Asymmetrical Impedance-source Converters
Z-Source converter or impedance-source converter is a kind of power converters, which has the responsibility to convert the direct current to alternative current. This converter with respect to its circuit diagram acts as a buck-boost converter except it doesn’t use from DC-DC converter bridge. Γ-source inverters are one of the conventional converters based on impedance-sources; which have been...
متن کاملImpedance Source Buck- Boost converter for linear and Non- Linear load using MATLAB simulation
This paper presents an alternative power conversion topology that can buck or boost the input voltage/current with linear and non-linear load depending upon duty ratio and modulation index in a single stage conversion with the help of Impedance source passive Network (L and C), which is usually known as Z-Source. The buck and boost capabilities of inverters are operated in the shoot through sta...
متن کاملA New Structure of Buck-Boost Z-Source Converter Based on Z-H Converter
In this paper, a new structure for buck-boost Z-source converter based on Z-H topology is proposed. The proposed converter consists of two LC networks similar to the conventional Z-source and Z-H converters. One of the characteristics of the proposed structure is that, without any changing in its’ power circuit, it can be used in different conversions such as dc/dc, dc/ac and ac/ac. This unique...
متن کاملA Repetitive Control- based Approach for Power Sharing among Boost Converters in DC Microgrids
In this paper a repetitive control (RC) approach to improve current sharing between parallel-connected boost converters in DC microgrids is presented. The impact of changes in line impedance on current sharing is investigated. A repetitive controller is designed and connected in series with current controller of the boost converters to control the switching signals such that by regulating of th...
متن کاملSimulation and Experimental Verification of Closed Loop Operation of Buck / Boost DC-DC Converter with Soft Switching
A major problem in an isolated DC/DC converters operating at high switching frequencies is the attendant switching losses in the semiconductor devices. This can be reduced by introducing either zero-voltage switching (ZVS) or zero-current switching (ZCS) of the semiconductor switches. This paper deals with the simulation, design, fabrication and experimental evaluation of a novel soft-switching...
متن کامل