Fabrication and Characterization of Fe-doped In2O3 Dilute Magnetic Semiconducting Nanowires
نویسندگان
چکیده
Junran Zhang, Xuefeng Wang, Zhongxia Wei, Zhenyao Wu, Meng Tang, Wei Niu, Ming Gao, Zhanpeng Lv, Wenqing Liu, Fengqi Song, Jun Du, Liang He, Rong Zhang, and Yongbing Xu National Laboratory of Solid State Microstructures, Collaborative Innovation Center of Advanced Microstructures, School of Electronic Science and Engineering, Nanjing University, Nanjing 210093, China National Laboratory of Solid State Microstructures, Collaborative Innovation Center of Advanced Microstructures, Department of Physics, Nanjing University, Nanjing 210093, China 3 York-Nanjing International Center of Spintronics (YNICS), Department of Electronics, The University of York, YO10 3DD, UK
منابع مشابه
High-performance transparent conducting oxide nanowires.
We report the growth and characterization of single-crystalline Sn-doped In2O3 (ITO) and Mo-doped In2O3 (IMO) nanowires. Epitaxial growth of vertically aligned ITO nanowire arrays was achieved on ITO/yttria-stabilized zirconia (YSZ) substrates. Optical transmittance and electrical transport measurements show that these nanowires are high-performance transparent metallic conductors with transmit...
متن کاملTransition-metal doped zinc oxide nanowires.
The introduction of impurity atoms into semiconducting materials is the primary method for controlling the properties of the semiconductor, such as band gap or electrical conductivity. This practice is routinely performed with bulk semiconductors and, more recently, has been extended to nanoscale semiconductors as well. In particular, II–VI and III–V semiconductors that have been doped with tra...
متن کاملGrowth and Characterization of Iron Nanowires Into Anodized Aluminum Oxide Templates Using Electrodeposition Technique
The Fe nanowires were prepared by Ac electrodeposition method. The two steps anodized aluminum oxides (alumina) were used as templates for electrodeposition of magnetic nanowires. Sulfuric acid was used to anodize aluminum. The pours diameter and growth rate of alumina were investigated. The FeSO4 electrolyte was used for growth of nanowires. The prepared magnetic nanowires were characterized b...
متن کاملElectrical, structural, and optical properties of sulfurized Sn-doped In2O3 nanowires
Sn-doped In2O3 nanowires have been grown on Si via the vapor-liquid-solid mechanism at 800 °C and then exposed to H2S between 300 to 600 °C. We observe the existence of cubic bixbyite In2O3 and hexagonal SnS2 after processing the Sn:In2O3 nanowires to H2S at 300 °C but also cubic bixbyite In2O3, which remains dominant, and the emergence of rhombohedral In2(SO4)3 at 400 °C. The resultant nanowir...
متن کاملSynthesis, characterization, and optical properties of In2O3 semiconductor nanowires.
In2O3 semiconductor nanowires were synthesized by the chemical vapor deposition method through carbon thermal reduction at 900 degrees C with 95% Ar and 5% O2 gas flow. The In2O3 nanowires were characterized by field emission scanning electron microscopy (FE-SEM), high-resolution transmission electron microscopy (HRTEM), and photoluminescence spectroscopy (PL). For the first time, we observed t...
متن کامل