S-band gain-clamped grating-based erbium-doped fiber amplifier by forward optical feedback technique.
نویسندگان
چکیده
An S-band gain-clamped erbium-doped fiber amplifier module, employing a fiber Bragg grating to serve as a reflected element for lasing a saturated tone injected into the module by forward optical feedback method, is proposed and investigated experimentally. Moreover, the performance and behavior of the gain and noise figure in the proposed gain-clamped S-band fiber amplifier have also been discussed in the effectively wavelength range of 1478 to 1520 nm.
منابع مشابه
Observation of Raman Gain in Reduced Length of Bismuth Erbium Doped Fiber
Raman amplification of a 49 cm Bismuth oxide (Bi2O3) as a nonlinear gainmedium based erbium doped fiber amplifier (EDFA) is reported in new and compactdesign in near infrared spectral regions. The bismuth glass host provides theopportunity to be doped heavily with erbium ions to allow a compact optical gain fiberamplifier design by using reduced fiber length and the 1480...
متن کاملDynamic adjustment for gain - clamping erbium - doped fiber amplifier using a backward - injection light
Erbium-doped fiber amplifiers ~EDFAs! have been intensively studied for wavelength-division-multiplexing ~WDM! communication systems. The stabilization of the amplifier gain against the input signal-power variation is one of the key issues for WDM networks. The gainstabilizing technique using a passive optical feedback device, such as a bandpass filter or a fiber Bragg grating, has been reporte...
متن کاملComparative Studies of the Thulium and Erbium Doped from 1480-1650 nm with Different Host Materials as Optical Fiber Amplifiers
This work describes the comparison of the amplification characteristics (gain) and the Noise figure (NF) of the Thulium and Erbium in three different host materials which the Yttria Alumina-Silica glass, Fluoride and Tellurite fiber glass. The gain using these host materials covers the range 1.45-1.65 μm. Thulium doped fiber amplifier (TDFAs) operated in the region of wavelength (1480-1510 nm) ...
متن کامل[ME01] An Efficient and Low Noise L-band Erbium-Doped Fiber Amplifier
Introduction The use of the long-wavelength-band (Lband) is attractive for both increasing the capacity of wavelength division multiplexing (WDM) systems and has been used in WDM transmission experiments at over 1 Tb/s. Recently, a gain bandwidth of about 80nm has been achieved by integrating the L-band EDFA in parallel with conventional band (Cband) EDFA [1]. Moreover, the L-band EDFAs will ma...
متن کاملNegative Feedback Semiconductor Optical Amplifiers and All-Optical Triode
The field of optical communications is moving toward the realization of photonic networks with wavelength division multiplexing (WDM) utilizing the full bandwidth of optical fibers. Conventionally, an erbium-doped fiber amplifier (EDFA) and a semiconductor optical amplifier (SOA) are used for amplifying an optical signal in optical communications. SOAs can contribute to this and offer the key a...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- Optics express
دوره 14 7 شماره
صفحات -
تاریخ انتشار 2006