Degenerate seaweed to tilted dendrite transition and their growth dynamics in directional solidification of non-axially oriented crystals: a phase-field study
نویسندگان
چکیده
We report the results of a phase-field study of degenerate seaweed to tilted dendrite transition and their growth dynamics during directional solidification of a binary alloy. Morphological selection maps in the planes of (G, Vp) and (ε4, Vp) show that lower pulling velocity, weaker anisotropic strength and higher thermal gradient can enhance the formation of the degenerate seaweed. The tip undercooling shows oscillations in seaweed growth, but it keeps at a constant value in dendritic growth. The M-S instability on the tips and the surface tension anisotropy of the solid-liquid interface are responsible for the formation of the degenerate seaweed. It is evidenced that the place where the interfacial instability occurs determines the morphological transition. The transient transition from degenerate seaweed to tilted dendrite shows that dendrites are dynamically preferred over seaweed. For the tilted dendritic arrays with a large tilted angle, primary spacing is investigated by comparing predicted results with the classical scaling power law, and the growth direction is found to be less sensitive to the pulling velocity and the primary spacing. Furthermore, the effect of the initial interface wavelength on the morphological transition is investigated to perform the history dependence of morphological selection.
منابع مشابه
Dynamics of low anisotropy morphologies in directional solidification.
We report experimental results on quasi-two-dimensional diffusion limited growth in directionally solidified succinonitrile with small amounts of poly(ethylene oxide), acetone, or camphor as a solute. Seaweed growth, or dense branching morphology, is selected by growing grains close to the [111] plane, where the in-plane surface tension is nearly isotropic. The observed growth morphologies are ...
متن کاملPhase-field modeling of the dendrite orientation transition in Al-Zn alloys
With a few exceptions, phase-field simulations of dendritic growth in cubic materials have been modeled using simple expressions for the interfacial energy anisotropy and with strong anisotropy. However, recent experimental results show that the Dendrite Orientation Transition (DOT) observed in Al-Zn alloys by Gonzales and Rappaz [Met. Mat. Trans. A37 (2006) 2797] occurs at weak anisotropy, and...
متن کاملX-ray tomographic microscopy analysis of the dendrite orientation transition in Al-Zn
Recently, Gonzales and Rappaz [Met. Mat. Trans. A37:2797, 2006] showed the influence of an increasing zinc content on the growth directions of aluminum dendrites. 〈100〉 and 〈110〉 dendrites were observed below 25wt.% and above 55wt.% zinc, respectively, whereas textured seaweeds and 〈320〉 dendrites were observed at intermediate compositions. Considering the complexity of these structures, it is ...
متن کاملDendritic Growth Morphologies in Al-Zn Alloys—Part II: Phase-Field Computations
In Part I of this article, the role of the Zn content in the development of solidification microstructures in Al-Zn alloys was investigated experimentally using X-ray tomographic microscopy. The transition region between h100i dendrites found at low Zn content and h110i dendrites found at high Zn content was characterized by textured seaweed-type structures. This Dendrite Orientation Transition...
متن کاملشببیه سازی تاثیر سرعت انجماد بر ریز ساختار آلیاژهای ریختگی آلومینیوم با استفاده از مدل شبکه عصبی مصنوعی
In cast aluminum and its alloys, the microstructure varies under different solidification conditions, causing variations in their mechanical properties. These materials are basically produced in sand and metallic molds or through die casting, each of which is associated with a unique solidification regime with significantly different cooling rates so that the resulting microstructure strongly d...
متن کامل