Investigation on the Consolidation Behaviour of Aluminium / nano - SiC Composite Powders Using Non - Linear Compaction Equation

نویسنده

  • M. Khoeini
چکیده

The densification response of aluminium powder reinforced with nanometric SiC particles (50 nm) during uniaxial compaction was studied. To determine the effect of SiC nanoparticles on the compressibility of the matrix, monolithic Al powder was also examined. The effect of SiC nanoparticles on the densification mechanisms, i.e. particle rearrangement and plastic deformation, was analysed using modified Cooper–Eaton equation. The results showed that with increasing the reinforcement volume fraction (up to 20 vol.-%), the contribution of particle rearrangement increases whilst the plastic deformation is limited. At high compaction pressures, the reinforcement particles significantly influence the yield pressure of the composite powder, retarding the densification. The influence of the reinforcement particle size is discussed in this paper. [H.R. Hafizpour, M. Khoeini. Investigation on the Consolidation Behaviour of Aluminium/nano-SiC Composite Powders Using Non-Linear Compaction Equation. Journal of American Science 2011;7(6):1258-1262]. (ISSN: 1545-1003). http://www.americanscience.org.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Fabrication and inspection of C/Cf-ZrB2-ZrC-SiC and C/Cf-ZrB2-SiC composite parts resistant to ablation by pressureless sintering method

In this research, the aim is to achieve strong and ablation-resistant composite parts C / Cf-ZrB2-ZrC-SiC and C / Cf-ZrB2-SiC by non-pressure sintering method. C / Cf-ZrB2-SiC samples were prepared using synthesized ZrB2 and SiC powders between layers of resin-impregnated carbon fabric. After pressing with pressure 5 times at 1600 وC and heat treatment for 2 hours in a controlled atmosphere fur...

متن کامل

AN INVESTIGATION ON CORROSION BEHAVIOUR OF A356-10 VOL.% SiC COMPOSITES IN HCl SOLUTIONS

In this study, corrosion behaviour of A356-10 vol.% SiC composites casted by gravity and squeeze casting is evaluated. For this purpose, prepared samples were immersed in HCl solution for 1h at open circuit potential. Tafel polarization and electrochemical impedance spectroscopy (EIS) were carried out to study the corrosion resistance of composites. The Tafel polarization and EIS studies of ...

متن کامل

Influences of Bath Stirring Rate on Synetics of Nano Composite Ni-SiC-Gr Coatings on St37 via Electrodeposition Process

In this study, electrochemical deposition of Ni-SiC-Gr nano composites was studied. The Watts bath was used for electrodeposition. The SiC and graphite powders were suspended in the electrolyte and stirred. The effects of changes in bath stirring rate on the composite coating were investigated. The X-Ray diffraction (XRD), scanning electron microscopy (SEM) and field emission scanning electron ...

متن کامل

A STUDY ON SINTERING BEHAVIORS OF COPPER COATED SIC COMPOSITE POWDERS FABRICATED BY ELECTROLESS PLATING AND MECHANICAL PROPERTIES OF THE CONSOLIDATED COMPOSITES

Copper coated SiC powders having three different amounts of copper, in the range of 20-60 wt%, were prepared via electroless coating process. The produced composite powders were uniaxially cold compressed and sintered at different temperatures and times under protective atmosphere. It was found that composite Cu/SiC powders and a relatively dense copper matrix composite with a uniform distribut...

متن کامل

Influence of Nano Reinforced Particles on the Mechanical Properties of Aluminium Hybrid Metal Matrix Composite Fabricated by Ultrasonic Assisted Stir Casting

During the past few decades, materials design has shifted emphasis to pursue low cost, quality, light weight, environment friendliness, and performance. Aluminium matrix composites are important class of engineering materials used in aerospace, automotive, engineering, defence and other industries because of their lower density, higher specific strength, and better physical and mechanical prope...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2011