Measurement of the Mass and Rigidity of Adsorbates on a Microcantilever Sensor
نویسندگان
چکیده
When microcantilevers are used in the dynamic mode, the resonance shift uponmaterial adsorption depends on the position of the adsorbate along the microcantilever. Wehave previously described that the adsorbate stiffness needs to be considered in addition toits mass in order to correctly interpret the resonance shift. Here we describe a method thatallows obtaining the Young's modulus of the adsorbed bacteria derived from themeasurement of the frequency shift when adsorbates are placed close to the clampingregion. As a model system we have used E. Coli bacteria deposited on the cantileversurface by the ink-jet technique. We demonstrate that the correct information aboutadsorbed mass can be extracted by recording the cantilever profile and its resonanceresponse. Also, the position and extent of adsorbates is determined by recording themicrocantilever profile. We use a theoretical model based on the Euler - Bernouilliequation for a beam with both mass and flexural rigidity local increase due to the depositedmaterial.
منابع مشابه
Effect of the Interparticle Interactions on Adsorption-Induced Frequency Shift of Nano-beam-Based Nanoscale Mass-Sensors: A Theoretical Study
It is well-known that the Interparticle interactions between adsorbates and surface of an adsorbent can affect the surface morphology. One of the consequences of this issue is that the resonant frequency of a nanoscale resonator can be changed due to adsorption. In this study we have chosen a cantilever-based nanoscale mass-sensor with a single nanoparticle at its tip. Using the classical...
متن کاملThe Measurement of Rigidity in Elbow Joint: An Objective Method for the Evaluation of Parkinson's disease
Introduction: One of the most common syndromes in Parkinson's disease (PD) is rigidity. Currently, an index is used to evaluate the level of PD by the clinical measurement of rigidity in the upper extremity. The index uses a subjective method called Unified Parkinson's Disease Rating System (UPDRS). The subjective nature of this method makes the influence of physician in the measurement of rigi...
متن کاملMicrocantilever Sensor via Second Order Sliding Mode Control
The mass sensor based on a microcantilever is considered. The mass loading on a sensor-microcantilever is computed by aligning a position of the sensor microcantilever with a reference one. The control function contains information about the loading mass. The problem is reduced to a time varying parameter identification in microcantilever sensors that is addressed via higher order sliding mode ...
متن کاملEffects of Fluid Environment Properties on the Nonlinear Vibrations of AFM Piezoelectric Microcantilevers
Nowadays, atomic-force microscopy plays a significant role in nanoscience and nanotechnology, and is widely used for direct measurement at atomic scale and scanning the sample surfaces. In tapping mode, the microcantilever of atomic-force microscope is excited at resonance frequency. Therefore, it is important to study its resonance. Moreover, atomic-force microscopes can be operated in fluid e...
متن کاملPull-in behavior of a bio-mass sensor based on an electrostatically actuated cantilevered CNT with consideration of rippling effect
This paper examines the pull-in behavior of a bio-mass sensor with a cantilevered CNT actuated electrostatically by considering rippling deformation. Although this phenomenon can remarkably change the behavior of CNT, its effect on the performance of a CNT-based mass sensor has not been investigated thus far. This investigation is based on modified Euler-Bernoulli beam theory and rippling effec...
متن کامل