Convergence rate across the Nepal Himalaya and interseismic coupling on the Main Himalayan Thrust: Implications for seismic hazard
نویسندگان
چکیده
[1] We document geodetic strain across the Nepal Himalaya using GPS times series from 30 stations in Nepal and southern Tibet, in addition to previously published campaign GPS points and leveling data and determine the pattern of interseismic coupling on the Main Himalayan Thrust fault (MHT). The noise on the daily GPS positions is modeled as a combination of white and colored noise, in order to infer secular velocities at the stations with consistent uncertainties. We then locate the pole of rotation of the Indian plate in the ITRF 2005 reference frame at longitude = 1.34 3.31 , latitude = 51.4 0.3 with an angular velocity of W = 0.5029 0.0072 /Myr. The pattern of coupling on the MHT is computed on a fault dipping 10 to the north and whose strike roughly follows the arcuate shape of the Himalaya. The model indicates that the MHT is locked from the surface to a distance of approximately 100 km down dip, corresponding to a depth of 15 to 20 km. In map view, the transition zone between the locked portion of the MHT and the portion which is creeping at the long term slip rate seems to be at the most a few tens of kilometers wide and coincides with the belt of midcrustal microseismicity underneath the Himalaya. According to a previous study based on thermokinematic modeling of thermochronological and thermobarometric data, this transition seems to happen in a zone where the temperature reaches 350 C. The convergence between India and South Tibet proceeds at a rate of 17.8 0.5 mm/yr in central and eastern Nepal and 20.5 1 mm/yr in western Nepal. The moment deficit due to locking of the MHT in the interseismic period accrues at a rate of 6.6 0.4 10 Nm/yr on the MHT underneath Nepal. For comparison, the moment released by the seismicity over the past 500 years, including 14 MW ≥ 7 earthquakes with moment magnitudes up to 8.5, amounts to only 0.9 10 Nm/yr, indicating a large deficit of seismic slip over that period or very infrequent large slow slip events. No large slow slip event has been observed however over the 20 years covered by geodetic measurements in the Nepal Himalaya. We discuss the magnitude and return period of M > 8 earthquakes required to balance the long term slip budget on the MHT.
منابع مشابه
Interseismic coupling on the main Himalayan thrust
We determine the slip rate and pattern of interseismic coupling on the Main Himalayan Thrust along the entire Himalayan arc based on a compilation of geodetic, interferometric synthetic aperture radar, and microseismicity data. We show that convergence is perpendicular to the arc and increases eastwards from 13.3 ± 1.7 mm/yr to 21.2 ± 2.0 mm/yr. These rates are comparable to geological and geom...
متن کاملAlong-strike changes in Himalayan thrust geometry: Topographic and tectonic discontinuities in western Nepal
Geodetic and seismologic studies support a tectonic model for the central Himalaya wherein ~2 cm/yr of Indo-Asian convergence is accommodated along the primary décollement under the range, the Main Himalayan thrust. A steeper midcrustal ramp in the Main Himalayan thrust is commonly invoked as driving rapid rock uplift along a range-parallel band in the Greater Himalaya. This tectonic model, dev...
متن کاملModeling mountain building and the seismic cycle in the Himalaya of Nepal
A host of information is now available regarding the geological and thermal structure as well as deformation rate across the Himalaya of central Nepal. These data are reconciled in a two-dimensional mechanical model that incorporates the rheological layering of the crust which depends on the local temperature and surface processes. Over geological timescale (5 Ma) the ""'20 mm/yr estimated shor...
متن کاملHimalayan megathrust geometry and relation to topography revealed by the Gorkha earthquake
The Himalayan mountain range has been the locus of some of the largest continental earthquakes, including the 2015 magnitude 7.8 Gorkha earthquake. Competing hypotheses suggest that Himalayan topography is sustained and plate convergence is accommodated either predominantly on the main plate boundary fault, or more broadly across multiple smaller thrust faults. Here we use geodetic measurements...
متن کاملActive folding of fluvial terraces across the Siwaliks Hills, Himalayas of central Nepal
We analyze geomorphic evidence of recent crustal deformation in the subHimalaya of central Nepal, south of the Kathmandu Basin. The Main Frontal Thrust fault (MFT), which marks the southern edge of the sub-Himalayan fold belt, is the only active structure in that area. Active fault bend folding at the MFT is quantified from structural geology and fluvial terraces along the Bagmati and Bakeya Ri...
متن کامل