Design and Analysis of a Distributed Regenerative Frequency Divider Using a Distributed Mixer

نویسندگان

  • Amin Q. Safarian
  • Payam Heydari
چکیده

In this paper we present the design and analysis of a distributed regenerative frequency divider (DRFD) based on a novel distributed single-balanced mixer. Artificial transmission lines are incorporated in the distributed single balanced mixer to absorb the parasitic capacitances. The circuit is realized in a 0.18 μm standard CMOS process. It shows a division by two for an input frequency of 40 GHz, while consuming 10 mW from a 1.8-V supply.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

A 28-36 GHz Optimized CMOS Distributed Doherty Power Amplifier with A New Wideband Power Divider Structure

Background and Objectives: In this paper, a new design strategy was proposed in order to enhance bandwidth and efficiency of power amplifier. Methods: To realize the introduced design strategy, a power amplifier was designed using TSMC CMOS 0.18um technology for operating in the Ka band, i.e. the frequency range of 26.5-40GHz. To design the power amplifier, first a power divider (PD) with a ver...

متن کامل

Design, Analysis and Simulation of a Linear Phase Distributed Amplifier

In this paper a new method for the design of a linear phase distributed amplifier in 180nm CMOS technology is presented. The method is based on analogy between transversal filters and distributed amplifiers topologies. In the proposed method the linearity of the phase at frequency range of 0-50 GHz is obtained by using proper weighting factors for each gain stage in cascaded amplifier topology....

متن کامل

Ultra-Widband Distributed Amplifier Using Loss Compensation Technique on Both Input and Output Circuit

In this paper, we analyze a distributed amplifier based on input/output attenuation compensation. The analysis is carried out for a HEMT transistor; and a constant-k section filter is used to calculate the amplifier’s characteristics such as attenuation factor, phase constant and gain. The proposed design approach enables us to examine the tradeoff among the variables, which include the type an...

متن کامل

Analysis and design of a CMOS current reused cascaded distributed amplifier with optimum noise performance

In this paper, analysis, simulation and design of a distributed amplifier (DA) with 0.13µm CMOS technology in the frequency range of 3-40 GHz is presented. Gain cell is a current reused circuit which is optimum in gain, noise figure, bandwidth and also power dissipation. To improve the noise performance in the frequency range of interest, a T-matching low pass filter LC network which is utilize...

متن کامل

Fully Distributed Modeling, Analysis and Simulation of an Improved Non-Uniform Traveling Wave Structure

Modeling and simulation of communication circuits at high frequency are important challenges ahead in the design and construction of these circuits. Knowing the fact that the lumped element model is not valid at high frequency, distributed analysis is presented based on active and passive transmission lines theory. In this paper, a lossy transmission line model of traveling wave switch (TWSW) i...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2004