Study of Single-Arm Electrode for ECG Measurement Using Flexible Print Circuit
نویسندگان
چکیده
--The purpose of this letter is to study a new ECG measurement by an annular FPC (flexible print circuit) electrode to the arm of the subject. This study attempts to use one FPC patch to measure ECG signals from a single-arm. The measurement system for the ECG circuit and analysis software was built to be able to measure and interpret the very weak and noisy ECG signals from the electrode. To compare with traditional three-point electrode measurement, this study will improve the patient uncomfortable and security. The results showed that the new ECG measurement system have the same capability compared to the traditional measurements for subjects at rest.
منابع مشابه
The reduction coefficient of PID controller by using PSO algorithm method for Flexible single-arm robot system
This study on the design of PID controllers for flexible single-arm robot system optimizationPSO method is focused so that the coefficients of the PID controller are reduced. In this study,PID controller and PSO algorithm have been described and then by using MATLAB, PIDcontrol was simulated. Then by PSO algorithm, attempts to reduce the PID coefficients are givenby simulation. Finally PID coef...
متن کاملBelt-type Wireless and Non-contact Electrocardiogram Monitoring System Using Flexible Active Electrode
Electrocardiogram (ECG) measurement using capacitively coupled electrode is a well-know method to get the ECG signal without direct skin-contact. In this paper, the belt-type system which measures ECG without direct skin-contact is designed and tested. The system consists of developed flexible active electrode (FAE), a driven-right-leg electrode and a module for signal processing and data acqui...
متن کاملFlexible Graphene Electrodes for Prolonged Dynamic ECG Monitoring
This paper describes the development of a graphene-based dry flexible electrocardiography (ECG) electrode and a portable wireless ECG measurement system. First, graphene films on polyethylene terephthalate (PET) substrates and graphene paper were used to construct the ECG electrode. Then, a graphene textile was synthesized for the fabrication of a wearable ECG monitoring system. The structure a...
متن کاملMOCA ARM: Analog Reliability Measurement based on Monte Carlo Analysis
Due to the expected increase of defects in circuits based on deep submicron technologies, reliability has become an important design criterion. Although different approaches have been developed to estimate reliability in digital circuits and some measuring concepts have been separately presented to reveal the quality of analog circuit reliability in the literature, there is a gap to estimate re...
متن کاملA Low-Power Bio-Potential Acquisition System with Flexible PDMS Dry Electrodes for Portable Ubiquitous Healthcare Applications
This work describes a bio-potential acquisition system for portable ubiquitous healthcare applications using flexible polydimethylsiloxane dry electrodes (FPDEs) and a low-power recording circuit. This novel FPDE used Au as the skin contact layer, which was made using a CO2 laser and replica method technology. The FPDE was revised from a commercial bio-potential electrode with a conductive snap...
متن کامل