The Influence of Swirl Brakes on the Rotordynamic Forces Generated by bischarge-to- Suction Leakage Flows in Centrifugal Pumps
نویسنده
چکیده
Increasing interest has been given to swirl brakes as a means of reducing destabilizing rotordynamic.forces due to leakage flows in new high speed rocket turbopumps. Although swirl brakes have been used successfully in practice {such as with the Space Shuttle HPOTP), no experimental tests until now have been pegormed to demonstrate their beneficial effect over a range of leakage flow rates. The present study investigates the effect of swirl brakes on rotordynamic forces generated by discharge-to-suction leakage flows in the annulus of shrouded rentrifuRa1 pumps over a range of subsynchronous whirl ratios and various leakage flow rates. In addition, the effectiveness of swirl brakes in the presence of leakage inlet (pump discharge) swirl is also demonstrated. The experimental data demonstrates that with the addition of swirl brakes a significant reduction in the destabilizing tangential force for lower flow rates is achieved. At higher jZow rates, the brakes are detrimental. In the presence of leakage inlet swirl, brakes were effective over all leakage flow rates tested in reducing the range of whirl frequency ratio for which the tangential force is destabilizing.
منابع مشابه
The Influence of Swirl Brakes and a Tip Discharge Orifice on the Rotordynamic Forces Generated by Discharge-to-suction ?.. Leakage Flows in Shrouded Centrifugal Pumps
Recent experiments conducted in the Rotor Force Test Facility at the California Institute of Technology have examined the effects of a tip leakage restriction and swirl brakes on the rotordynamic forces due to leakage flows on arl impeller undergoing a prescribed circular whirl. The experiments simulate the leakage flow conditions and geometry of the Alternate Turbopump Design (ATE)) of the Spa...
متن کاملEffect of Swirl on Rotordynamic Forces Caused by Front Shroud Pump Leakage
Unsteady forces generated by fluid flow through the impeller shroud leakage path of a centrifugal pump were investigated. The effect of leakage path inlet swirl (pump discharge swirl) on the rotordynamic forces was re-examined. It was observed that increasing the inlet swirl is destabilizing both for normal and tangential rotordynamic forces. Attempts to reduce the swirl within the leakage path...
متن کاملRotordynamic Forces from Discharge- to-Suction Leakage Flows in Centrifugal Pumps
The rotordynamic forces generated by the fluid flow through the impeller leakage path of a centrifugal pump are now well established. The present paper examines the effects of modifying the leakage path geometry by changing the front shroud, from a conical shape to a more typical curved design, and the effects of low pressure seal design on these forces. It is found that only the cross-coupled ...
متن کاملModel Predictions and Experimental Results for the Rotordynamic Characteristics of Leakage Flows in Centrifugal Pumps
Adiei GlIinzburg is a Research Scientisl at the l nsfifll l de Machines Hydrau /iques et de Mecaniqlle des Fluides at the EcoLe Polytechn ique Federate de Lausallne, Switzerland. She IIo/eisa B.Sc. degree in AeronaMical Engineeringfrom the University a/the Witwatersrand and M.S. and Ph.D. degrees from the CaLifornia Institute a/ Technology. Christopher E. Brennen is a Professor of Mechanical En...
متن کاملUpthrust Problems on Multistage Vertical Turbine Pumps
Vertical turbine pumps are designed to operate with the pump shafts in tension (downthrust). Most pump and motor manufacturers caution users to not operate the vertical turbine pumps at conditions that result in “upthrust.” Upthrust conditions are usually encountered for a few seconds each time the pump is started; however, the pump should not be operated for periods longer than a few seconds i...
متن کامل