Intrinsic surface band bending in Cu3N„100... ultrathin films
نویسندگان
چکیده
C. Navío,1,* M. J. Capitán,2 J. Álvarez,1 F. Yndurain,1 and R. Miranda1 1Departamento de Física de la Materia Condensada e Instituto de Ciencia de Materiales Nicolás Cabrera, Universidad Autónoma de Madrid, Cantoblanco, 28049 Madrid, Spain 2Instituto de Estructura de la Materia-CSIC, c/Serrano 119, 28006 Madrid, Spain Received 8 March 2007; revised manuscript received 31 May 2007; published 6 August 2007
منابع مشابه
The Effect of Substrate on Structural and Electrical Properties of Cu3N Thin Film by DC Reactive Magnetron Sputtering
The aim of this paper is to study the effect of substrate on the Cu3N thin films. At first Cu3N thin films are prepared using DC magnetron sputtering system. Then structural properties, surface roughness, and electrical resistance are studied using X-ray diffraction (XRD), the atomic force microscope (AFM) and four-point probe techniques respectively. Finally, the results are investigated and c...
متن کاملBand Bending in Mg-Colored and O2‐Activated Ultrathin MgO(001) Films
Ultrathin MgO films grown on Ag(001) have been investigated using X-ray and ultraviolet photoemission spectroscopies for oxide films successively exposed to Mg and O2 flux. Studying work functions and layer-resolved Auger shifts allows us to keep track of band profiles from the oxide surface to the interface and reveal the charge-transfer mechanisms underlying the controlled creation of Mg-indu...
متن کاملUltrathin CVD Cu Seed Layer Formation Using Copper Oxynitride Deposition and Room Temperature Remote Hydrogen Plasma Reduction
Cu seed layers for future interconnects must have conformal step coverage, smooth surface morphology, and strong adhesion. Conformal deposition had been achieved by chemical vapor deposition CVD , but CVD Cu films have rough surfaces and poor adhesion. In this paper, conformal, smooth, adherent, continuous, and thin 9 nm Cu films were made by CVD. CuON was deposited from a Cu-amidinate precurso...
متن کاملFacile preparation of copper nitride powders and nanostructured films
The simple fluorinated precursor, copper(II) trifluoroacetate, Cu(CF3COO)2 can be effectively utilised in the synthesis of copper(I) nitride, Cu3N, powders and films by combinations of wet processing and gas–solid (ammonolysis) techniques. The resulting materials were characterized by powder X-ray diffraction (PXD), scanning electron microscopy (SEM) with energy dispersive X-ray spectroscopy (E...
متن کاملDetermination of the surface band bending in InxGa1−xN films by hard x-ray photoemission spectroscopy
Core-level and valence band spectra of In x Ga1-x N films were measured using hard x-ray photoemission spectroscopy (HX-PES). Fine structure, caused by the coupling of the localized Ga 3d and In 4d with N 2s states, was experimentally observed in the films. Because of the large detection depth of HX-PES (∼20 nm), the spectra contain both surface and bulk information due to the surface band bend...
متن کامل