Emc Computer Modelling and Simulation of Integrated Circuits in Qfn Package
نویسندگان
چکیده
This paper discusses the application of computational electromagnetics (CEM) for electromagnetic compatibility (EMC) problems of integrated circuits (ICs). It is known that the application of CEM is versatile in solving a wide range of problems. This paper focuses on the electromagnetic study of quad flat non-lead (QFN) packaged ICs, one monolithic microwave integrated circuit (MMIC) and another radio frequency integrated circuit (RFIC), from the individual chip to system in package (SiP). Full-wave electromagnetic technique is conducted in the modelling and simulation. Both chips are found producing radiated emissions in horizontal directions as omnidirectional antennas at working frequencies and then directional at resonance frequencies.
منابع مشابه
A MEMS Capacitive Microphone Modelling for Integrated Circuits
In this paper, a model for MEMS capacitive microphone is presented for integrated circuits. The microphone has a diaphragm thickness of 1 μm, 0.5 × 0.5 mm2 dimension, and an air gap of 1.0 μm. Using the analytical and simulation results, the important features of MEMS capacitive microphone such as pull-in voltage and sensitivity are obtained 3.8v and 6.916 mV/Pa, respectively while there is no...
متن کاملEffect of Molding Compound and Die Attach Adhesive Material on Qfn Package Delamination and Warpage Issues
The presence of thermal mismatch between different materials of plastic IC packages was found to cause reliability and moldability issues such as delamination and warpage phenomenon. Delamination and warpage between the mold compound and die attach adhesive material were evaluated for Quad Flat No-lead (QFN) package. Evaluation was conducted on two set of different materials combination of epox...
متن کاملWarpage and Wire Sweep Analysis of Qfn Molded Array Strip Using Modeling and Experimental Methods
In this paper, both experimental and modeling works were resorted to analyze the warpage and wire sweep of QFN molded strip. The effect of QFN package size was investigated to provide the relation between warpage and metal to mold compound ratio. Design guideline for optimum metal to mold compound ratio has been obtained. Nonlinear large deformation of finite element analysis has been performed...
متن کاملShear Stress Analysis of Different Stacked Die Qfn Package Using Fem
Package of stacked die QFN nowadays become more popular in semiconductor industry because of its lead less, good electrical performance and its small size. However, it is not an easy task to manufacture a robust stacked die QFN. Usually, die shear test will be conducted with specified condition to test the die strength. Die contains circuit that is significant part of the package. In this paper...
متن کاملElectromagnetic compatibility of integrated circuits
Through lectures (6 H) Understand parasitic emission mechanisms Introduce parasitic emission reduction strategies Give an overview of emission and susceptibility measurement standards Power Decoupling Network modelling Basis of conducted and radiated emission modelling Basis of immunity modelling Understand the role of decoupling at printed-circuit-board level Acquire basic knowledge of design ...
متن کامل