Surface Modification of Polymer Materials Induced by Laser Irradiation
نویسنده
چکیده
We report on the surface modification effects using allyl‐diglycol CR39 polymer induced by laser irradiation at 157 nm F2 laser (VUV) and 248 nm KrF laser. The motivation is to investigate the ablation effects on this polymer in optical waveguides application the ablation effects on this polymer in optical waveguides. Fabrication of waveguides has been observed using continuous wave (CW) at 244 nm argon ion laser. Ablation effects on the surface of this polymer have been characterized including ablation threshold at different wavelengths from the assorted depth of craters formed from UV pulsed laser. Application of this polymer in optical waveguide application is corroborated by the refractive index value on the CR39 channels that varied as fluences changed when using the continuous wave UV irradiation. A limit for upper fluence at the point where laser ablation originates on this polymer has also been determined.
منابع مشابه
Surface Wettability Modification of Cyclic Olefin Polymer by Direct Femtosecond Laser Irradiation
The effect of laser irradiation on surface wettability of cyclic olefin polymer (COP) was investigated. Under different laser parameters, a superhydrophilic or a superhydrophobic COP surface with a water contact angle (WCA) of almost 0° or 163°, respectively, could be achieved by direct femtosecond laser irradiation. The laser power deposition rate (PDR) was found to be a key factor on the wett...
متن کاملLaser-induced chemical micro-treatment and synthesis of materials
Laser-induced technological chemical processes can significantly contribute to the development of new methods for micro treatment of materials and hence to the broadening of the application spectrum of laser microtechnology. In this paper three typical laser-activated chemical technological methods in liquids, gases and solids and their possible applications are presented and discussed: First, ...
متن کاملLaser ablation and waveguide fabrication using CR39 polymer
We report on the ablation and fabrication of optical waveguide using allyl-diglycol CR39 polymer. Pulse nanosecond (ns) laser (248 nm KrF) and continuous wave (CW) (244 nm argon-ion) irradiation are performed to observe surface modification on the polymer and potentially utilize it for channel waveguide. The pulsed UV laser creates craters with different depth as fluence increases to quantify t...
متن کاملCharacterization and Corrosion Behavior of Hydroxyapatite- Coated Titanium Substrates Prepared Through Laser Induced Liquid Deposition Technique
Titanium and titanium alloys are often used in orthopedic surgery and dentistry because of their especial characteristics such as biocompatibility, mechanical properties, and corrosion resistance. However, their bio- inertness is the most serious drawback for biomedical applications. Therefore, a bioactive coating like hydroxyapatite (HA) is coated on their surface. In this regard, in the prese...
متن کاملGamma irradiation induced surface modification of silk fabrics for antibacterial application
Silk fabrics were modified by a treatment of silver nitrate solution (AgNO3) and polyvinylpyrrolidone (PVP) as a stabilizer then exposure to γ-irradiation to create antibacterial properties. Effects of the absorbed dose on treated fabrics were investigated. The scanning electron microscopy (SEM) and X-ray diffraction (XRD) patterns were used to confirm the presence of silver nanoparticles (AgNP...
متن کامل