On Coupling Co2 Corrosion and Multiphase Flow Models
نویسندگان
چکیده
Corrosion prediction in multiphase flow has been a challenging task in oil and gas industry for many years. Strictly speaking, the existing mechanistic CO2 corrosion models can only be used in single-phase flow. To add the capability of predicting corrosion in multiphase flow, the mass transfer and the turbulent diffusivity correlations in the models have to be modified to properly calculate the mass flux of corrosion species. An approach for establishing these correlations in different flow regimes is presented. The implementation of the method for stratified flow proves the feasibility of this proposal.
منابع مشابه
Corrosion in Multiphase Flow Containing Small Amounts of H2s
Experiments in a large-scale flow loop provide an example of a somewhat increased corrosion rate under multiphase flow conditions caused by a low concentration of H2S in a CO2 saturated environment. Under operating conditions that prevent scale formation, the addition of 3ppm H2S in the gas phase increased the corrosion rate of AISI C 1018 and API 5L X-65 carbon steels, while the addition of H2...
متن کاملCo2 Corrosion Model Verification Using Field Data
An integrated multiphase flow and corrosion prediction package was tested by comparing it’s performance with data obtained from the field. The comparisons indicated a satisfactory performance, even for the situations where incomplete information was available about the field cases. The results have shown that the effect of traces of H2S on CO2 corrosion needs to be given particular care when ma...
متن کاملCorrosion Science Section
Water wetting is a crucial issue in carbon dioxide (CO2) corrosion of multiphase flow pipelines made from mild steel. This study demonstrates the use of a novel benchtop apparatus, a horizontal rotating cylinder, to study the effect of water wetting on CO2 corrosion of mild steel in two-phase flow. The setup is similar to a standard rotating cylinder except for its horizontal orientation and th...
متن کاملEffects of Multiphase Flow on Corrosion Inhibitor
This paper investigates the inhibition performance of a typical imidazoline based inhibitor under multiphase flow. Electrochemical impedance spectroscopy (EIS) measurements were carried out in a 101.6 mm I. D.,15 m long acrylic flow loop using ASTM substitute saltwater and carbon dioxide gas. This flow loop system can generate slug flow, fill pipe flow and other multiphase flow patterns. Effect...
متن کاملCoupled modeling of multiphase flow and fault poromechanics during geologic CO2 storage
Coupling between fluid flow and mechanical deformation in porous media plays a critical role in geologic storage of CO2. One of the key issues in simulation of CO2 sequestration is the ability to describe the mechanical and hydraulic behavior of faults, and the influence of the stress tensor and change in pressure on fault slip. Here, we present a new computational approach to model coupled mul...
متن کامل