Phase III experimental results of JAERI /USDOE collaborative program on fusion neutronics
نویسنده
چکیده
A pseudo-line D-T neutron source has been developed with new experimental techniques. This line source was applied in sophisticated neutronics experiments for an annular blanket arrangement simulating the tokamak geometry, as a new series in the JAERI/USDOE collaborative experimental program on fusion neutronics. The source characteristics of the present line source and the measurements for an annular assembly are described. The discussion on the experimental results focuses on the tritium production rate measured in an annular blanket and comparisons were made with the previous point source experiment, and also between the annular blankets with and without an armor reflector of graphite.
منابع مشابه
Overview of the latest experiments under the JAERI /USDOE collaborative program on fusion neutronics
The JAERI /USDOE collaborative program is going on using the FNS facility at JAERI. The phase-III is a new series on tritium breeding measurements with a totally different experimental arrangement from the previous ones that used a point neutron source geometry. The new series basically consists of an annular test blanket and a pseudo-line source to investigate the effect of source spread on th...
متن کاملPost-analysis for the line source phase IIIA experiments of the USDOE/JAERI collaborative program on fusion neutronics
Experimental simulation to a line source has been realized at FNS, JAERI, within the USDOE/JAERI collaborative Program on Fusion Neutronics. This simulation achieved by cyclic movement of an annular Li20 test assembly relative to a stationary point source was a step forward in better simulation of the energy and angular distributions of the incident neutron source found in Tokamak plasmas. Thus...
متن کاملExperimental verification of the current data and methods for induced radioactivity and decay heat calculation in D - T fusion reactors
Induced radioactivities and decay heat are of significant importance in the nuclear design of a near-term D-T fusion device from the view point of the safety consideration. In the framework of the JAERI/USDOE collaborative program on fusion neutronics, extensive experimental efforts have been devoted to verify the validity of the calculation code systems THIDA-2, REACT-2 and DKR-ICF. In the pre...
متن کاملDirect nuclear heating measurements in fusion neutron environment and analysis
Experimental measurement of nuclear heating rates has been carried out in a simulated D-T fusion neutron environment from 1989 through 1990 under the USDOE/JAERI collaborative program at the Fusion Neutronics Source Facility. The microcalorimetric technique has been employed for online measurements. Small probes of materials have been irradiated in close vicinity of a rotating target. A typical...
متن کاملIntegral experiment of induced radioactivity in D-T fusion neutron environment and validation of activation cross section library
Under ITER/EDA R&D Task T-218, an integral experiment on the induced radioactivity was conducted at the Fusion Neutronics Source (FNS) facility in JAERI. The objective was to provide experimental data for validating the inventory calculation codes and relevant activation cross section libraries to be used in the ITER nuclear design. Sample materials investigated were Al, Mg, Ti, V, Mn, Fe, Ni, ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2002