Module 2 - Optical Fiber Materials

نویسنده

  • B. G. Potter
چکیده

Dr. B.G.Potter is a Professor of Material Science and Engineering in the University of Arizona. Research activity within Dr. Potter's group is centered on the synthesis and study of glass, ceramic, and molecular hybrid materials for photonic and electronic applications. Active research and ongoing programs include: optically driven molecular assembly strategies, nanostructured photovoltaic energy conversion materials, photoactivated phenomena in glass and hybrid thin films, solution and physical vapor phase deposition of thin films and nanocomposites (oxides, inorganic-organic hybrids), thermal stability of complex oxide optical materials, environmental sensing, optical behavior of rare-earth-doped matrices, semiconductor quantum-dot ensembles, and optical spectroscopy.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Jitter Measurements

The TTCrx mezzanine card was installed on the Clock and Control Board [2] and connected to a TTCvx module via a 100 m optical cable. The TTCvx provided the 40.00 Mhz clock source for the TTCvi module. Measurements were conducted while repeatedly transmitting two broadcast (BC) commands over channel B and L1 Accept over channel A (case 1) and then again without the BC commands / L1 Accepts (case...

متن کامل

An overview of micromachining for optical communications - Optical Fiber Communication. OFC 97., Conference on

Figure 3(a) shows a temperature dependence ofthe fiber output and monitor current for one of the fabricated 50 samples of the plastic module. The fiber output was 0.2 mW in the full operating temperature range from -40-85°C. The monitor current was >lo0 (*.A at 0.2 mW fiber output and the trackingwidth of < + -20% was obtained in the full temperature range. The rise and fall time ofthe transmit...

متن کامل

Compact Optical Splitter Module for FTTH Outside Plant

PON system has expanded extensively as an optical network in the construction of FTTH economically. As shown in Fig. 1, PON architecture allows a signal transmitted over a single optical fiber from the telephone exchange office to be shared with multiple users, hence achieving cost reduction per subscriber. Planar lightwave circuit (PLC), an optical splitter is a key to realize the branching of...

متن کامل

Biwavelength transceiver module for parallel simultaneous bidirectional optical interconnections

The design of a biwavelength transceiver (TRx) module for parallel simultaneous bidirectional optical interconnects is described. The TRx module has been implemented using two different wavelengths, 850 and 1060 nm, to send and receive signals simultaneously through a common optical interface while optimizing cost and performance. Filtering mirrors are formed in the optical fibers which are emb...

متن کامل

High Transmission Bit Rate of A thermal Arrayed Waveguide Grating (AWG) Module in Passive Optical Networks

In the present paper, high transmission bit rate of a thermal arrayed waveguide grating (AWG) which is composed of lithium niobate (LiNbO3)/polymethyl metha acrylate (PMMA) hybrid materials on a silicon substrate in Passive Optical Networks (PONs) has parametrically analyzed and investigated over wide range of the affecting parameters. We have theoretically investigated the temperature dependen...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2010