Analysis of clock buffer phase noise
نویسندگان
چکیده
This paper presents a phase noise model for clock buffers. The model can be used to predict the phase noise introduced by clock buffers and to gain insight into phase noise transfer mechanisms in clock buffers. Based on the models, techniques for low phase noise clock buffer design are derived. The analytical results presented here have good agreement with simulation and measurement results. Comments Copyright 2002 IEEE. Reprinted from Proceedings of the 2002 IEEE International Symposium on Circuits and Systems (ISCAS 2002), Volume 5, pages 657-660. Publisher URL: http://ieeexplore.ieee.org/xpl/tocresult.jsp?isNumber=21767&page=11 This material is posted here with permission of the IEEE. Such permission of the IEEE does not in any way imply IEEE endorsement of any of the University of Pennsylvania's products or services. Internal or personal use of this material is permitted. However, permission to reprint/republish this material for advertising or promotional purposes or for creating new collective works for resale or redistribution must be obtained from the IEEE by writing to [email protected]. By choosing to view this document, you agree to all provisions of the copyright laws protecting it. This conference paper is available at ScholarlyCommons: http://repository.upenn.edu/ese_papers/61
منابع مشابه
A Very Low Voltage 9th Order Linear Phase Baseband Switched Capacitor Filter (RESEARCH NOTE)
A very low voltage 9th order linear phase baseband switched capacitor (SC) filter has been designed to be used as part of a cellular GSM (Global System Mobile) receiver. A Gaussian-to-6dB filter of the order of seven is chosen and a second order function is added to reduce the group delay variations around. The filter uses a fully differential topology to increase the dynamic range and reduce t...
متن کاملA 2.2GHz Sub-Sampling PLL with 0.16psrms Jitter and -125dBc/Hz In-band Phase Noise at 700μW Loop-Components Power
A divider-less PLL exploits a phase detector that directly samples the VCO with a reference clock. No VCO sampling buffer is used while dummy samplers keep the VCO spur <-56dBc. A modified inverter with low short-circuit current acts as a power efficient reference clock buffer. The 2.2GHz PLL in 0.18μm CMOS achieves -125dBc/Hz in-band phase noise with only 700μW loop-components power. Introduct...
متن کاملA Low-Power Adaptive Bandwidth PLL and Clock Buffer With Supply-Noise Compensation
This paper describes a fully integrated low-jitter CMOS phase-locked loop and clock buffer for low-power digital systems with a wide range of operating frequencies. The design uses static CMOS inverters as a building block of the voltage-controlled oscillator and clock buffering. To reduce supply-induced jitter, programmable circuits with opposite sensitivity compensate for the delay variations...
متن کاملA Fast-Locking All-Digital Deskew Buffer with DCC using Digital-Controlled Delay Line
This paper presents a wide range fast lock all-digital deskew buffer using a digital controlled delay line, which achieves low jitter, fast lock, low power consumption and 50% duty cycle correction. A cyclic time-to-digital converter is introduced to decrease the locking time in conventional register-controlled delay-locked loop. A balanced edge combiner to achieve 50% output clock is also pres...
متن کاملPerformance Analysis Of Mono-bit Digital Instantaneous Frequency Measurement (Difm) Device
Instantaneous Frequency Measurement (IFM) devices are the essential parts of anyESM, ELINT, and RWR receiver. Analog IFMs have been used for several decades. However, thesedevices are bulky, complex and expensive. Nowadays, there is a great interest in developing a wideband, high dynamic range, and accurate Digital IFMs. One Digital IFM that has suitably reached allthese requirements is mono-bi...
متن کامل