Dynamic Characteristics of Automotive Steel Sheets
نویسنده
چکیده
M. Mihaliková, A. Lišková, Faculty of Metallurgy, Technical University of Košice, Slovakia The aim of this experimental research was to perform an analysis of deformation characteristics on two different types of steel: IF steel, and micro-alloyed steel were used automotive industry. For that purpose changes of properties of these materials were carried out by static 10-3 · s-1 and dynamic 103 · s-1 strain rate assess its plastic properties. Vickers micro hardness test was carried out by the static and dynamic loading condition and describes different hardness distribution. The higher strain hardening of materials was obtained too that was confirmed by distribution of dislocations.
منابع مشابه
Increments of Plastic Strain and Hardness Hv10 of Automotive Steel Sheets
M. Mihaliková, M. Német, Faculty of Metallurgy, Technical University of Košice, Slovakia The present paper deals with measurements of the increments of strain and hardness HV10 on automotive steel sheets. The car body manufacture trends are focused, in particular, on high energy absorption capability. In the manufacture of a car body, there are requirements for high plasticity and homogeneity o...
متن کاملExperimental and analytical investigation of dynamic crack patterns in automotive windshield sheets subjected to low velocity impact
Off-road cars’ windshields are vulnerable to different types of stones, road debris and pebbles due to common off paved and gravel surfaces in which they drive. Any attempt to design windshield that minimizes injury and death of occupants during a vehicle accident requires a thorough understanding of the mechanical behavior of automotive windshield subjected to foreign object impact loads...
متن کاملFormation oF outburst struCturE in hot dip galvannEalEd Coatings on iF stEEls
Rapid development of automotive industry brings also increased requirements for sheets properties, involving relatively high strength and good formability together with excellent corrosion resistance. Increasing requests for corrosion resistance lead to the production of coated car parts, protected mainly by zinc coatings. Whereas, majority of European producers of passenger cars use preferenti...
متن کاملAn Experimental and Numerical Study of Forming Limit Diagram of Low Carbon Steel Sheets
The forming limit diagram (FLD) is probably the most common representation of sheet metal formability and can be defined as the locus of the principal planar strains where failure is most likely to occur. Low carbon steel sheets have many applications in industries, especially in automotive parts, therefore it is necessary to study the formability of these steel sheets. In this paper, FLDs, wer...
متن کاملTensile property improvement of TWIP-cored three-layer steel sheets fabricated by hot-roll-bonding with low-carbon steel or interstitial-free steel
TWIP-cored three-layer steel sheets were newly fabricated by hot rolling of TWIP steel sheet surrounded by low-carbon (LC) or interstitial-free (IF) steel sheets. TWIP/LC or TWIP/IF interfaces were well bonded without pores or voids, while a few pearlites were thinly formed along the interfaces. The strengths and elongation of the TWIP-cored sheets increased as the volume fraction of TWIP-cored...
متن کامل