Antennae on transmitters on penguins: balancing energy budgets on the high wire.
نویسندگان
چکیده
The effect of externally mounted antennae on the energetics of penguins was studied by mounting various antennae on a transducer fixed to a model Magellanic penguin Spheniscus magellanicus to determine drag, run at speeds of up to 2 m s(-1) in a swim canal. For rigid antennae set perpendicular to the water flow, measured drag increased with increasing swim speed. Increasing antenna length (for lengths between 100 and 200 mm) or diameter (for diameters between 1 and 4 mm) resulted in accelerating increased drag as a function of both antenna length and diameter. Where antennae were positioned at acute angles to the water flow, drag was markedly reduced, as was drag at higher speeds in flexible antennae. These results were incorporated in a model on the foraging energetics of free-living Magellanic penguins using data (on swim speeds, intervals between prey encounters, amount ingested per patch and dive durations) derived from previously published work and from a field study conducted on birds from a colony at Punta Norte, Argentina, using data loggers. The field work indicated that free-living birds have a foraging efficiency (net energy gain/net energy loss) of about 2.5. The model predicted that birds equipped with the largest rigid external antennae tested (200 mm x 3 mm diameter), set perpendicular to water flow, increased energy expenditure at normal swim speeds of 1.77 m s(-1) by 79% and at prey capture speeds of 2.25 m s(-1) by 147%, and ultimately led to a foraging efficiency that was about 5 times less than that of unequipped birds. Highly flexible antennae were shown to reduce this effect considerably. Deleterious antenna-induced effects are predicted to be particularly critical in penguins that have to travel fast to capture prey. Possible measures taken by the birds to increase foraging efficiency could include reduced travelling speed and selection of smaller prey types. Suggestions are made as to how antenna-induced drag might be minimized for future studies on marine diving animals.
منابع مشابه
Balancing under the high wire; a study into PTT antenna effects on the Common Guillemot [i]Uria aalge[i]
External tags fitted to diving birds can affect them in many ways with the most critical effect being an increase in drag. The effects of transmitters can be even more acute due to the presence of a protruding aerial. The study assesses the impact of PTT antenna on the behaviour and energetics of device-equipped guillemots (Uria aalge) in captivity. Birds with antenna-devices appeared to consum...
متن کاملAn experimental analysis and optimization of machining rate and surface characteristics in WEDM of Monel-400 using RSM and desirability approach
In the present work, an experimental investigation on wire electrical discharge machining (WEDM) of Monel-400 has been presented. Monel-400 is a nickel–copper-based alloy, mostly employed in ships and corrosion-resisting applications. Four input WEDM parameters namely discharge current (Ip), pulse-on time (Ton), pulse-off time (Toff) and servo voltage (SV) have been investigated and modeled for...
متن کاملLow metabolism in a tropical bat from lowland Panama measured using heart rate telemetry: an unexpected life in the slow lane.
Animals must optimize their daily energy budgets, particularly if energy expenditures are as high as they are in flying animals. However, energy budgets of free-ranging tropical animals are poorly known. Newly miniaturized heart rate transmitters enabled this to be addressed this in the small, energetically limited, neotropical bat Molossus molossus. High-resolution 48 h energy budgets showed t...
متن کاملLEBRP - A Lightweight and Energy Balancing Routing Protocol for Energy-Constrained Wireless Ad Hoc Networks
A wireless ad hoc network typically refers to any set of wireless networks where all devices have equal status on a network and are free to associate with any other wireless ad hoc network devices in their range. As the nature of these networks, they commonly do not have external power supplies, and each node has a limited internal power source. In this paper, we put forward a new routing proto...
متن کاملExperimental Investigation of Surface Roughness and Kerf Width During Machining of Blanking Die Material on Wire Electric Discharge Machine
Wire electric discharge machine (WEDM) is spark erosion in unconventional machining technique to cut hard and the conductive material with a wire as an electrode. The blanking die material SKD 11 is a high carbon and high chromium tool steel with high hardness and high wearing resistance property. This tool steel has broad application in press tools and dies making industries. In this research ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- The Journal of experimental biology
دوره 207 Pt 15 شماره
صفحات -
تاریخ انتشار 2004