The skull development of parrots with special reference to the emergence of a morphologically unique cranio-facial hinge.

نویسنده

  • Masayoshi Tokita
چکیده

The order Psittaciformes (parrots) has unique morphological features in the head that are evolutionarily novel. To better understand the unique evolution of the head in parrots, the developmental pattern of the skull of the budgerigar (Melopsittacus undulatus) was initially described on the basis of transparent skeletal specimens. Although the fundamental pattern of the skull development of birds is conserved in parrots, some differences were observed between parrots and other groups of birds. In parrots, the vacuity in the interorbital septum did not emerge throughout ontogeny, in contrast to other lineages of birds, for example Galliformes and Coliiformes. This feature seems to be concerned with the attachment of the unique jaw muscle of parrots, M. ethmomandibularis, to the interorbital septum. In spite of a prokinetic skull, the cranio-facial hinge of parrots was brought about by secondary transformation of dermal bones unlike that of birds with a standard prokinetic skull (e.g. Corvus) in which the nasal-frontal suture directly becomes a hinge of bending. To further understand the evolution of "pseudoprokinesis" in parrots, the construction of a robust avian phylogeny is desired. The parrot-specific suborbital arch and cranio-facial hinge are not seen until birds leave the nest and can feed themselves. In conclusion, these structures are considered to be essential for eating hard and/or large meals.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Improvement of vitrification of in vitro produced buffalo embryos with special reference to sex ratio following vitrification

Cryopreservation and sexing of embryos are integrated into commercial embryo transfer technologies. To improve the effectiveness of vitrification of in vitro produced buffalo embryos, two experiments were conducted. The first evaluated the effect of exposure time (2 and 3 min) and developmental stage (morula and blastocysts) on the viability and development of vitrified buffalo embryos. Morphol...

متن کامل

Assessment of the relation between stature and Cranio-facial variables in students of Shiraz University of Medical Sciences

Aim Anthropometric data, particularly cranio-facial variables, is important in forensic medicine, sex determination, designing ergonomic instrument and plastic surgery. The aim of present study is to determine the relation between stature and facial length and facial width among students in Shiraz University of Medical Sciences. Methods This study was done on 201 students (100 males and 101 fem...

متن کامل

Results of End-To-Side Hypoglossal-Facial Nerve Anastomosis in Facial Paralysis after Skull Base Surgery

Introduction: The primary aim of facial reanimation surgery is to restore tone, symmetry, and movement to the paralyzed face. Hypoglossal-facial end-to-side anastomosis provides satisfactory facial reanimation in the irreversible proximal injury of the facial nerve. This study discussed the facial function results of end-to-side anastomosing of hypoglossal nerve to facial nerve when the i...

متن کامل

Paediatric Dose AssessmentToward Establishment of National Diagnostic Reference Levels for Digital Radiography Examinations in Iran

Introduction: Paediatric patients deserve special attention because of the higher radiation risks compared with adults. The main purpose of this study is to determine patient dose and diagnostic reference level for Paediatric through Entrance Surface Dose (ESD) calculations in common X-ray examination and to establish Paediatric national DRLs in digital radiography in Iran. <...

متن کامل

Silicone rubber mould cast polyethylmethacrylate-hydroxyapatite plate used for repairing a large skull defect.

INTRODUCTION Reconstruction of the cranial vault is performed for various reasons and precise repair of the defect is important. A modified method of cranioplasty is presented using three-dimensional (3D) models and polyethylmethacrylate mixed with hydroxyapatite, cast in a silicone rubber mould. PATIENT AND METHOD A large custom made cranial implant was produced using data acquired from 3D c...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • Zoological science

دوره 20 6  شماره 

صفحات  -

تاریخ انتشار 2003