The Microstructure and Wear Resistance of a Copper Matrix Composite Layer on Copper via Nitrogen-Shielded Arc Cladding

A TiN and TiN·Ti2Cu reinforced copper matrix composite layer was cladded onto a T3 copper substrate to improve the anti-wear performance of copper products by means of the nitrogen-shielded gas tungsten arc cladding method (N2-GTAC). Better than the traditional preparation method of TiN, the TiN particles in the cladding layer were in situ generated using N atoms of shielding gas and Ti atoms of pre-deposited metal powders. In addition, the composite phase TiN·Ti2Cu occurred in the cladding layer, which also had a positive effect on anti-wearing. As Ti increased, the amount and grain size of TiN·Ti2Cu and TiN increased as a result. The hardness of the cladding layer increased with the increasing amount of reinforced phase generated in the layer. The hardness of the layer reached a maximum of 410 HV, which is nearly 5.1 times greater than that of copper. The TiN·Ti2Cuand TiN-reinforced phases improved the wear resistance of the cladding layers. The cladding layer with 15 wt % Ti had the longsest launch stage (600 s) and the lowest fiction coefficient (0.56).