Thermoelectric Cooler Based Temperature Controlled Environment Chamber Design for Application in Optical Systems

Temperature control is widely sought after in regards to optical systems as their optical parameters often show dependence on temperature. Examples include diode lasers, multiplexing systems, optical amplifiers, and filters all of whom have a high sensitivity to temperature. This thesis presents a temperature controlled environment chamber actuated by a thermoelectric cooler. The design of which provides a simple, multi-applicable solution for temperature control in optical devices. The final device is comprised of three sub-areas of design. Each subsystem was custom built and applied in the final assembly – including a digitally implemented signal generator, an error correction controller, and the environment chamber heat sink structure. The signal generator is used as input for a switched-mode based Peltier driver found commercially. A feedback error controller compensates the driver for temperature control. Both systems are implemented with microcontroller units. The environment chamber heat sink assembly is designed specifically to handle the thermal energy generated by the thermoelectric cooler. All of the systems were tested collectively for functionality. The input signal generator achieved its design goals and is capable of creating specific profiles in the temperature response. Error controller performance was reasonable in set-point tracking for continuous input signals. Step input responses are tuned for minimal settling time and overshoot. Temperature resolution in the thermistor response is around 0.1°C after digital filtering. The thermal design achieved its goal of operating in an ambient environment up to 54°C. Low temperature ambient environment operation has been confirmed to 8°C.