RFC 3214 LSP Modification Using CR - LDP
نویسنده
چکیده
This document presents an approach to modify the bandwidth and possibly other parameters of an established CR-LSP (Constraint-based Routed Label Switched Paths) using CR-LDP (Constraint-based Routed Label Distribution Protocol) without service interruption. After a CR-LSP is set up, its bandwidth reservation may need to be changed by the network operator, due to the new requirements for the traffic carried on that CR-LSP. The LSP modification feature can be supported by CR-LDP by use of the _modify_value for the _action indicator flag_ in the LSPID TLV. This feature has application in dynamic network resources management where traffic of different priorities and service classes is involved. Ash, et al. Standards Track [Page 1] RFC 3214 LSP Modification Using CR-LDP January 2002
منابع مشابه
Improvement of performance in MPLS domains by using caching and aggregation of CR-LSP
Constraint-based routing (CR-LDP) extends the features of MPLS Label Distribution Protocol (LDP) working in conjunction with a wide variety of QoS scenarios and services including IP differentiated services, integrated services, traffic engineering, Asynchronous Transfer Mode (ATM) service classes and frame relay. When a large number of CR-LSPs are required a lot of CR-LDP signalling is needed:...
متن کاملDesign and implementation of MPLS network simulator supporting LDP and CR-LDP
The explosive growth of the Internet and the advent of sophisticated services require an epoch-making change. As an alternative that can take in it, MPLS was proposed. Recently, many efforts and activities on MPLS have already been initiated, which prompt the necessity of MPLS simulator that can evaluate and analyze newly proposed MPLS techniques. This paper describes design, implementation, an...
متن کاملMaximum Transmission Unit Signalling Extensions for the Label Distribution Protocol
Proper functioning of RFC 1191 path Maximum Transmission Unit (MTU) discovery requires that IP routers have knowledge of the MTU for each link to which they are connected. As currently specified, the Label Distribution Protocol (LDP) does not have the ability to signal the MTU for a Label Switched Path (LSP) to the ingress Label Switching Router (LSR). In the absence of this functionality, the ...
متن کاملMultipoint LDP In-Band Signaling for Point-to-Multipoint and Multipoint-to-Multipoint Label Switched Paths
Consider an IP multicast tree, constructed by Protocol Independent Multicast (PIM), that needs to pass through an MPLS domain in which Multipoint LDP (mLDP) point-to-multipoint and/or multipoint-tomultipoint Labels Switched Paths (LSPs) can be created. The part of the IP multicast tree that traverses the MPLS domain can be instantiated as a multipoint LSP. When a PIM Join message is received at...
متن کاملMultipoint LDP (mLDP) In-Band Signaling with Wildcards
There are scenarios in which an IP multicast tree traverses an MPLS domain. In these scenarios, it can be desirable to convert the IP multicast tree "seamlessly" into an MPLS Multipoint Label Switched Path (MP-LSP) when it enters the MPLS domain, and then to convert it back to an IP multicast tree when it exits the MPLS domain. Previous documents specify procedures that allow certain kinds of I...
متن کامل