Comfort and Functional Properties of Far-Infrared/Anion-Releasing Warp-Knitted Elastic Composite Fabrics Using Bamboo Charcoal, Copper, and Phase Change Materials
نویسندگان
چکیده
Elastic warp-knitted composite fabrics with far-infrared emissivity and an anion-releasing property were prepared using bamboo charcoal (BC), copper (Cu), and phase-change material (PCM). The functional composite fabric, which was composed of self-made complex yarns with various twisting degrees and material composition, were created using a rotor twister and ring-spinning technique. The fabric structure was diversified by the feeding modes of weft yarn into a crochet-knitting machine. The twist number of complex yarns was optimized by tensile tenacity, twist contraction, and hairiness, and analysis showed that twisting at 12 twists per inch produced the highest tensile tenacity and appropriate twist contraction and hairiness. Comfort evaluation showed that the elastic composite fabrics with BC weft yarns exhibited higher water–vapor transmission rate and air permeability, reaching 876 g/m2 ̈ day and 73.2 cm3/s/cm2, respectively. Three structures of composite fabric with various weft yarns had >0.85 ε far-infrared emissivity and 350–420 counts/cm3 anion amount. The prepared elastic warp-knitted fabrics can provide a comfortable, dry, and breathable environment to the wearer and can thus be applied as health-care textiles in the future.
منابع مشابه
Mechanical Properties of Composite Materials Made of 3D Stitched Woven-knitted Preforms
This article presents an experimental investigation carried out to understand the mechanical behavior of composite materials made of 3D stitched woven-knitted basalt fabrics. The innovative preforms used consist of two outer layers of a plain woven fabric combined with two inner layers of weft-knitted fabrics. The weft-knitted fabrics selected for the study were varied plain knit, 1 × 1 rib, Mi...
متن کاملA Comparison Study of Fabric Objective Measurement (FOM) Using KES-FB and PhabrOmeter System on Warp Knitted Fabrics Handle – Smoothness, Stiffness and Softness
This paper conducts a comparison study using KES-FB and PhabrOmeter to measure 58 selected warp knitted fabric hand properties. Fabric samples were selected and measured by both KES-FB and PhabrOmeter. Results show differences between these two measurement methods. Smoothness and stiffness values obtained by KES-FB were found significant correlated (p value = 0.003 and 0.022) to the PhabrOmeter...
متن کاملWarp-Knitted Fabrics Simulation Using Cardinal Spline and Recursive Rotation Frame
To realize 3-D simulation of warp-knitted fabrics, this paper proposes a 3-D loop modeling method based on Cardinal spline and recursive rotation frame method. Fabric structure and loop geometry are studied to form a visible lapping detection model and loop geometrical key points obtained according to chain links and yarn arrangements. In this paper, eight points are set for stitched loop and t...
متن کامل