Assembly Influence on the Small-Signal Parameters of a Packaged Transistor
نویسندگان
چکیده
A detailed analysis of the assembly influence on the small-signal parameters of a packaged transistor is presented. A new method, based on 3D field simulation and mixed-mode scattering parameters approach is proposed. Differences in scattering parameters caused by assembly change are computed using the new proposed method and compared to the standard method based on admittance matrix. The differences, accuracy, error sources and suitability of both methods are discussed. Results are verified experimentally in microstrip line for two fundamental assembly changes of a transistor in SOT 343 package in frequency range 45 MHz 18 GHz.
منابع مشابه
Analysis of Kirk Effect in Nanoscale Quantum Well Heterojunction Bipolar Transistor Laser
In this paper, we present an analytical model to analysis the kirk effect onstatic and dynamic responses of quantum well heterojunction bipolar transistor lasers(HBTLs). Our analysis is based on solving the kirk current equation, continuityequation and rate equations of HBTL. We compare the performance (current gain,output photon number and small signal modulation bandwi...
متن کاملDesign and Fabrication of a 911 GHz Balanced Low Noise Amplifier Using HJFET
This paper describes the design of an X-band balanced low noise amplifier (LNA) using an available HJFET device. The balanced LNA consists of a pair of electrically similar transistors whose input and output signals are divided or combined by 3 dB two-stage Wilkinson power dividers. The proposed balanced LNA is fabricated and measured. The measured results show that the noise figure is 1.30 dB ...
متن کاملModelling and Simulation of Low-Head Hydro Turbine for Small Signal Stability Analysis in Power System
The hydro turbine dynamics have a considerable influence on the dynamic stability of power system. In the study of dynamic stability, the system is modeled by the linear differential equations (small signal analysis). Small signal stability of power systems is needed in all conditions and only is dependent on the conditions of power system performance before commotion occurrence. This paper pr...
متن کاملThe Influence of Effective Factors on Mechanical Stress on Fingertips During Snap-fit Assembly
Objectives: Nowadays, Snap-fits are used in the automotive industry as a proper alternative for mechanical joints, cabling joints, and car interior lining joints. Due to the special form of these joints, which are assembled manually, the contact area between Snap-fits and the worker’s fingertips can be too small. This can cause skin pain on the worker’s fingertips. Therefore, ...
متن کاملANNs in Bias Dependant Small-Signal and Noise Modeling of Microwave FETs
In this paper an efficient procedure for determination of small-signal and noise behavior of microwave transistors for various bias conditions is proposed. An empirical transistor noise model based on an equivalent circuit (improvement of Pospieszalski’s noise model) is considered. Since it is necessary to extract values of the model equivalent circuit for each bias point (which requires the me...
متن کامل