RFC 5283 LDP Extension for Inter - Area LSPs July 2008
نویسنده
چکیده
Status of This Memo This document specifies an Internet standards track protocol for the Internet community, and requests discussion and suggestions for improvements. Please refer to the current edition of the "Internet Official Protocol Standards" (STD 1) for the standardization state and status of this protocol. Distribution of this memo is unlimited. Abstract To facilitate the establishment of Label Switched Paths (LSPs) that would span multiple IGP areas in a given Autonomous System (AS), this document describes a new optional Longest-Match Label Mapping Procedure for the Label Distribution Protocol (LDP). This procedure allows the use of a label if the Forwarding Equivalence Class (FEC) Element matches an entry in the Routing Information Base (RIB). Matching is defined by an IP longest-match search and does not mandate an exact match.
منابع مشابه
Controlling State Advertisements of Non-negotiated LDP Applications
There is no capability negotiation done for Label Distribution Protocol (LDP) applications that set up Label Switched Paths (LSPs) for IP prefixes or that signal point-to-point (P2P) Pseudowires (PWs) for Layer 2 Virtual Private Networks (L2VPNs). When an LDP session comes up, an LDP speaker may unnecessarily advertise its local state for such LDP applications even when the peer session is esta...
متن کاملLabel Distribution Protocol Extensions for Point-to-Multipoint and Multipoint-to-Multipoint Label Switched Paths
This document describes extensions to the Label Distribution Protocol (LDP) for the setup of point-to-multipoint (P2MP) and multipoint-to-multipoint (MP2MP) Label Switched Paths (LSPs) in MPLS networks. These extensions are also referred to as multipoint LDP. Multipoint LDP constructs the P2MP or MP2MP LSPs without interacting with or relying upon any other multicast tree construction protocol....
متن کاملREEQOS: An RSVP-TE approach for the End-to-End QoS provisioning within MPLS Domains
This paper exposes a new approach, denoted REEQOS, for supporting QoS both in intra and interdomain, generally named autonomous system (AS)[RFC 1771]. This approach is based firstly on MPLS technology and uses RSVP-TE extension (RFC 3209) for establishing two kinds of Label switched paths: I-LSP (Internal LSP) within every AS and E-LSP (External LSP) for inter AS routing. RSVP-TE is used in a l...
متن کاملInter-AS Requirements for the Path Computation Element Communication Protocol (PCECP)
Multiprotocol Label Switching Traffic Engineered (MPLS TE) Label Switched Paths (LSPs) may be established wholly within an Autonomous System (AS) or may cross AS boundaries. The Path Computation Element (PCE) is a component that is capable of computing constrained paths for (G)MPLS TE LSPs. The PCE Communication Protocol (PCECP) is defined to allow communication between Path Computation Clients...
متن کاملMultipoint LDP In-Band Signaling for Point-to-Multipoint and Multipoint-to-Multipoint Label Switched Paths
Consider an IP multicast tree, constructed by Protocol Independent Multicast (PIM), that needs to pass through an MPLS domain in which Multipoint LDP (mLDP) point-to-multipoint and/or multipoint-tomultipoint Labels Switched Paths (LSPs) can be created. The part of the IP multicast tree that traverses the MPLS domain can be instantiated as a multipoint LSP. When a PIM Join message is received at...
متن کامل