T-Loop Position and Anchorage Control: A Finite Element Study
نویسندگان
چکیده
Objective: To determine the effect of T loop spring position and activation on moment to force ratio. Materials and methods: Study conducted in two parts: (1) By using loop software by Halazonetis. Parameters studied were later on evaluated using FEM. Material properties along with the cross-sectional parameters being the same as in FEM, (2) using FEM, a large deflection nonlinear static analysis was carried. Results: This study revealed that, as amount of force increased and position of T-loop changed, the M/F ratio changed. Conclusion: Not only activation but also change in position of loop has a definite effect on moment and M/F ratio. Different clinically simulating designs have been evaluated.
منابع مشابه
Second Molar Uprighting with Temporary Anchorage Devices: A Finite Element Study
BACKGROUND AND OBJECTIVE: Premature loss of mandibular first molar is a common problem in adults. Mesial tipping of second molar may occur in this situation. Various orthodontic mechanics have been proposed for molar uprighting. The aim of this study was to compare four methods of molar uprighting using Finite Element Analysis(FEM). METHODS: In first model of this finite element study, a 0.019...
متن کاملAn Investigation on the Behavior of Retaining Structure of Excavation Wall Using Obtained Result from Numerical Modeling and Monitoring Approach. (A Case Study of International "Narges Razavi 2 Hotel", Mashhad)
With the growing population and density in metropolitan areas, higher tendency to live in high-rise buildings, and increasing demand for parking lots, it seems necessary to excavate soil to construct underground spaces. During excavation work, as the height of the wall increases, special care should be taken to the wall stabilization to avoid any consequent damage including extensive property d...
متن کاملInvestigation into the Curling Intensity of Polyester/Cotton Single Jersey Weft Knitted fabric Using Finite Element Method
Curling of knitted fabrics edges is one of the complicated problems of these structures. Therefore, study and measurement of curling in knitted fabrics is important. In this study, it is tried to model the three-dimensional wale wise curl of the fabric using finite element modelling. In this model the tensions in different parts of a knitted loop due to bending and torsional forces in knitting ...
متن کاملDesign, Construction and Comparison of a Sensorless Driver Circuit for Switched Reluctance Motor
In the presented paper, a sensorless driver circuit is designed, constructed and tested to control two types of three-phase Switched Reluctance Motor (SRM). The presented control algorithm has three steps. In the first step, the SRM is controlled by an open-loop method. In the second step, mathematical model of the SRM phase, motor parameters and flux-current-rotor position relation are used in...
متن کامل