Probing excitationyionization processes in millisecond-pulsed glow discharges in argon through the addition of nitrogen

نویسندگان

  • Glen P. Jackson
  • Fred L. King
چکیده

The addition of N to a millisecond-pulsed glow discharge (PGD) allows diagnostic measurements of the PGD but 2 is found to drastically influence the transient signals arising from the argon and sputtered analyte atoms. Penning excitation between metastable argon atoms and ground state nitrogen molecules and charge transfer between argon ions and the added nitrogen reduce the degree of ionization of sputtered atoms during the power-on, plateau, period by a factor of ;10 (at 1% N by vol.). The added nitrogen affects sputtered atom emission signals less at this time 2 because electron excitation dominates the excitation of these species. Upon power termination, afterpeak, the added nitrogen prevents plasma recombination in two major mechanisms: (i) the nitrogen reduces the number of argon ions available for recombination in the afterpeak; and (ii) vibrationally excited states of nitrogen slow the thermalization of electrons thereby decreasing recombination efficiency. The argon ion population contributes significantly to the afterpeak increase in the number of metastable argon atoms. These atoms are essential for the afterpeak ionization of sputtered atoms. Judicious selection of the nitrogen partial pressure can tune the delay time of afterpeak ionizationy recombination by up to 200 ms. This could be particularly beneficial for time-resolved optical or mass spectrometric analyses. 2002 Elsevier Science B.V. All rights reserved.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Spectroscopic Characterisation of an Atmospheric Pressure Glow Discharge*

Recently there has been considerable interest in atmospheric discharges operating in a glow discharge mode i.e. with a spatial and sheath structure similar to that of low pressure glow discharges [1,2,3]. Here spectroscopy has been used to characterise an atmospheric pressure glow discharge (APGD), operating with either dry air, argon or helium gas flowing through the inter-electrode space and ...

متن کامل

Spectral, spatial and temporal characteristics of a millisecond pulsed glow discharge: metastable argon atom production

Time resolved atomic emission, atomic absorbance, and laser-induced atomic fluorescence measurements of a Ž3 . millisecond pulsed glow discharge, made perpendicular to the insertion probe, provide temporal profiles of 1s P 5 2 Ž3 . and 1s P metastable argon atom populations. Acquisition of these profiles at different spatial positions in the 3 0 plasma provides data from which two-dimensional s...

متن کامل

Modeling of a millisecond pulsed glow discharge: Investigation of the afterpeak

We have developed a comprehensive modeling network for a millisecond pulsed glow discharge in argon (Ar) with copper (Cu) cathode, to describe the behavior of the various plasma species. Typical results of the model are shown, such as the potential distribution during and after the pulse, the densities of Ar ions, Ar atoms in the metastable and various other excited levels, Cu atoms and Cu ions...

متن کامل

Spectral, spatial and temporal characterization of a millisecond pulsed glow discharge: copper analyte emission and ionization

Two-dimensional maps of the spatial distributions of excited and ionized sputtered copper atoms are presented for a millisecond pulsed argon glow discharge. These maps demonstrate the temporal as well as spatial dependence of different excitation and ionization processes over the pulse cycle. Transitions from the low energy electronic states Ž . for the atom, characterized by emission such as t...

متن کامل

Influence of Argon Gas Concentration in N2-Ar Plasma for the Nitridation of Si in Abnormal Glow Discharge

Nitriding of p-type Si samples by pulsed DC glow discharge is carried out for different Ar concentrations (30% to 90%) in nitrogen-argon plasma whereas the other parameters like pressure (2 mbar), treatment time (4 hr) and power (175 W) are kept constant. The phase identification, crystal structure, crystallinity, chemical composition, surface morphology and topography of the nitrided layer are...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2003