Reduction of guard interval by impulse compression for DMT modulation on twisted pair cables
نویسندگان
چکیده
In multicarrier modulation schemes like Orthogonal Frequency Division Multiplex (OFDM) or Discrete Multi Tone (DMT) a guard interval represented by a cyclic prefix (CP) is inserted between successive multicarrier symbols in order to reduce intersymbol interference (ISI). The length of the guard interval is determined by the length of the channel impulse response (CIR). For a fixed guard interval, the longer the CIR, the higher the ISI is. In this paper, we have designed a time domain equalizer (TEQ) to compress the impulse response of several twisted pair lines with and without bridged taps. The reduction of ISI is shown as well as the resulting signal to noise ratio (SNR) in the presence of white Gaussian noise, near and far end crosstalk (NEXT, FEXT) for various equalizer designs.
منابع مشابه
An efficient equalization method to minimize delay spread in OFDM/DMT systems
Abstract– A time domain equalization technique to be used in an Orthogonal Frequency Division Multiplex (OFDM) or Discrete Multi Tone (DMT) system is proposed, which directly minimizes the delay spread of the overall channel impulse response (CIR). It will be shown that this technique can provide superior performance compared to recent developments of equalizers, which are designed to maximize ...
متن کاملDiscrete Multitone Modulation With Principal Component Filter Banks
Discrete multitone (DMT) modulation is an attractive method for communication over a nonflat channel with possibly colored noise. The uniform discrete Fourier transforn (DFT) filter bank and cosine modulated filter bank have in the past been used in this system because of low complexity. We show in this paper that principal component filter banks (PCFB) which are known to be optimal for data co...
متن کاملAn efficient model for twisted-pair cables with discontinuities and stubs for discrete time simulations
This paper describes an efficient model for twistedpair cables suitable for discrete time simulations. The model uses a pole-zero approximation for the cable losses, and a modified s-parameter approach to model the reflections due to discontinuities and stubs. Use of this model can improve simulation times by a factor of ten compared to using the conventional method of including the channel imp...
متن کاملJoint transmitter/receiver design for multicarrier data transmission with low latency time
In this paper a design method for low latency multicarrier transmission is presented. It can be considered as a generalization of the Trailing-Zeros Transmitter approach in [1]. The generalization mainly consists of using FIR redundant filter banks for the transmitter and receiver instead of pure block transforms and allowing to choose the guard interval independently of the channel impulse res...
متن کاملPerformance analysis of multicarrier modulation systems using cosine modulated filter banks
In this paper we compare the performance of biorthogonal cosinemodulated transmultiplexer filter banks with today’s multicarrier modulation systems whose transceivers are based on DFT. In contrast to early works on transmultiplexer filter banks that concentrated on the derivation of perfect reconstruction constraints of the filter bank or prototype design, this study takes into consideration a ...
متن کامل