Compositional evolution of Q-phase precipitates in an aluminum alloy

نویسندگان

  • Aniruddha Biswas
  • Donald J. Siegel
  • David N. Seidman
چکیده

Lightweight, age-hardenable aluminum alloys are attracting increasing attention as a means to reduce vehicle mass and improve fuel economy. To accelerate the adoption of these alloys, knowledge of the complex precipitation processes that underlie their primary strengthening mechanism is essential. Here we employ a combination of atom-probe tomography (APT), differential scanning calorimetry (DSC), transmission electron-microscopy, X-ray diffraction and first-principles calculations to reveal the compositional evolution of Q-phase precipitates in a commercial, age-hardenable aluminum alloy, W319. Three different aging conditions are investigated: 438 K/8 h, 463 K/8 h and 533 K/4 h. Co-precipitation of h0and Q-phase precipitates is observed for all aging conditions, which, when combined with DSC analysis of the precipitation sequence, suggests that Q-phase precipitates serve as heterogeneous nucleation sites for h0-platelets. Regarding composition evolution, aging at the lower temperatures yields Q-phase precipitates that are Cu-rich, yet deficient in Mg and Si: 44Al–22Cu–16Mg–16.5Si at.%. The composition evolves to become Mg-rich after aging at 533 K: 28Al–9Cu–37Mg– 26Si at.%. APT provides evidence for partitioning of Zn to the Q-phase precipitates. The energetics of Zn partitioning was evaluated using first-principles calculations, and suggests that this partitioning is a kinetic effect. Our analyses provide new insights into the complex precipitation processes in commercial Al alloys, and should foster the enhancement of alloy performance through optimization of aging conditions. 2014 Acta Materialia Inc. Published by Elsevier Ltd. All rights reserved.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Study of the Enhanced Precipitation of an Aluminium 6061 Alloy Reinforced by SiC Particles in the Range of β\" Phase Temperature (RESEARCH NOTE)

An experimental method to follow the evolution of the precipitation phenomena in the metal-matrix composites using the thermoelectric power measurements is described. It is shown that one can follow the kinetics of the precipitation during aging. The influence of the reinforcement on the precipitation kinetics is studied in case of an aluminum 6061- SiC, composite (where SiC, represents SiC par...

متن کامل

EFFECT OF THE INCLINED COOLING PLATE CHARACTERISTICS ON THE THIXOTROPIC MICROSTRUCTURE OF A356.0 ALUMINUM ALLOY

In the present work microstructural evolution of A356 Aluminum alloy using an inclined cooling plate casting process for thixoforming feedstock production is investigated. The resultant microstructure was evaluated and compared with those of the same alloy produced by the conventional casting process, i.e. directly cast in the same mold without using an inclined cooling plate. It was found that...

متن کامل

Enhancing the low cycle fatigue strength of AA6061 aluminum alloy by using the optimized combination of ECAP and precipitation hardening

In the present study, mechanical properties and low cycle fatigue behavior of a solid-solutionized AA6061 aluminum alloy produced by equal channel angular pressing (ECAP) process were investigated. The grain refinement after two passes of ECAP significantly increased the yield stress and ultimate tensile stress and decreased the ductility of the alloy. However, the improvement of low cycle fati...

متن کامل

Phase-field Modeling with CALPHAD and CVM for Microstructural Evolution of Ni-base Superalloy

To perform a quantitative simulation using the Phase Field Method (PFM) in a real alloy system, a new strategy of modeling the microstructure evolution of Ni-base superalloy is proposed in the present paper. In this strategy, the Calculation Phase Diagram (CALPHAD) method and Cluster Variation Method (CVM) are combined with the PFM, in which the four sub-lattice model is used to evaluate the fr...

متن کامل

Development of a Nanoscale Precipitation-Strengthened Creep-Resistant Aluminum Alloy Containing Trialuminide Precipitates

Development of a Nanoscale Precipitation-Strengthened Creep-Resistant Aluminum Alloy Containing Trialuminide Precipitates Keith Edward Knipling This research is toward developing a castable andheat-treatable precipitation-strengthened aluminum alloy exhibiting coarseningand creep resistance at temperatures exceeding 400°C. Criteria for selecting alloying elements capable of producing such an al...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2014