Injection and Extraction at Damping Ring of an Electron-positron Injection Complex Vepp5
نویسندگان
چکیده
Engineering aspects of electron and positron injection, storage and extraction in a damping ring of an injection complex are described. Symmetrical strip-line type kickers are used in quasi-traveling wave mode. A generator of a pair of negative and positive polarity pulses bases on two double pulse forming network (DPFN). Both DPFN are charged up to 50 kV using a common pulse transformer. Every DPFN is commutated by single high-voltage hydrogen thyratron. One of the thyratrons has a floating cathode. Special design resistors are used as kicker terminators. Circuit wave resistance is 25 Ohm, pulses duration is 80 ns, and repetition rate is up to 50 Hz.
منابع مشابه
Updated Design of the Italian Superb Factory Injection System
The ultra high luminosity B-factory (SuperB) project of INFN [1, 2] requires a high performance and reliable injection system, providing electrons at 4 GeV and positrons at 7 GeV, to fulfill the very tight requirements of the collider. Due to the short beam lifetime, continuous injection of electrons and positrons in both High Energy Ring (HER) and Low Energy Ring (LER) is necessary to keep the...
متن کاملPEP-II Injection Timing and Controls
Hardware has been built and software written and incorporated in the existing SLC accelerator control system to control injection of beam pulses from the accelerator into the PEP-II storage rings currently under construction. Hardware includes a CAMAC module to delay the machine timing fiducial in order that a beam pulse extracted from a damping ring will be injected into a selected group of fo...
متن کاملOptimization of Positron Capture in Nlc
In the Next Linear Collider design [1], the positron capture system includes a positron production target, followed by a short solenoid with a strong magnetic field (flux concentrator), a 250 MeV linac with solenoidal focusing, a 1.73 GeV linac with quadrupole focusing and an energy compressor system before injection into the positron pre-damping ring (see Fig. 1 for initial part of collector)....
متن کاملA New Structure for the NLC Positron Predamping Ring Lattice
The NLC positron source is specified to produce a beam of normalized edge emittance 30,000 mm-mrad. It is not practicable, using a single damping ring, to damp this emittance to meet the specification for injection into the main linac, so a pre-damping ring is used to reduce the emittance to a value at least as small as that of the electron beam from the source. In this note, we describe the de...
متن کاملProgress on PEP-II Injection R&D*
judicious use of the SLC linac, damping rings, and positron High-energy ring (HER) Low-energy ring (LER) source.. Particles per bunch ._, -. _ II. ROLE OF R&D PROGRAM IN OVERALL PEP-II INJECTION High-energy ring (HER) Low-energy ring (LER) The overall goals of the PEP-II Injection System are Linac repetition rate summarized in Table 1. These differ from those given in Linac current range during...
متن کامل