Liquid phase dispersion in bubble columns operating in the churn-turbulent flow regime
نویسندگان
چکیده
The objective of this paper is to develop a reliable, yet-simple, correlation for the liquid phase axial dispersion coefficient Dax,L in bubble column reactors. In order to develop this correlation we carried out measurements of the centre-line liquid velocity VL(0) and Dax,L in bubble columns of diameter DT=0.174, 0.38 and 0.63 m with the air-water system. The measurements were performed in the churn-turbulent regime of operation with superficial gas velocities U in the range 0.05–0.35 m/s. From the several literature correlations tested, the one proposed by Riquarts [Chem. Ing. Techn. 53, 1981, 60-61] can be recommended for estimation of VL(0) for air–water systems. The Riquarts correlation however anticipates the dependence of VL(0) on the kinematic viscosity of the liquid phase. Measurements of VL(0) were also carried out in the 0.38 m diameter column with Tellus oil as the liquid phase, with a kinematic viscosity 87 times that of water. Comparison of VL(0) measurements with water and Tellus oil shows a negligible influence of liquid viscosity, leading us to conclude that the best estimation procedure for VL(0) is to use the Riquarts correlation with properties of the water as the liquid phase. The above conclusions are also supported by Eulerian simulations of the bubble column hydrodynamics. Our measured data on the Dax,L and VL(0) were combined to develop a simple correlation: Dax,L=0.31 VL(0) DT; this correlation also provides a good description of experimental data from the literature. © 2000 Elsevier Science S.A.
منابع مشابه
A Study of Gas Flow in a Slurry Bubble Column Reactor for the DME Direct Synthesis: Mathematical Modeling from Homogeneity vs. Heterogeneity Point of View
In the present study, a heterogeneous and homogeneous gas flow dispersion model for simulation and optimization of a large-scale catalytic slurry reactor for the direct synthesis of dimethyl ether (DME) from synthesis gas (syngas) and CO2, using a churn-turbulent regime was developed. In the heterogeneous flow model, the gas phase was distributed into two bubble phases including small and large...
متن کاملNumerical Simulation of Dynamic Flow Behaviour in a Bubble Column: Comparison of the Bubble-Induced Turbulence Models in the k-ε Model
Numerical simulations of the gas-liquid bubbly flow in a bubble column were conducted with the commercial CFD package CFX-4.4 to investigate the performance of three models (Pfleger and Becker, 2001; Sato and Sekoguchi, 1975; Troshko and Hassan, 2001) to account for the bubble-induced turbulence in the k-ε model. Furthermore, the effect of two different interfacial closure models was investigat...
متن کاملRise velocity of a swarm of large gas bubbles in liquids
This paper develops a procedure for estimation of the rise velocity of a swarm of large gas bubbles in a bubble column operating in the churn-turbulent flow regime. The large bubble swarm velocity is estimated by introducing two correction factors into the classical Davies—Taylor (1950) relation for rise of a single spherical cap bubble in a liquid » b "0.71Jgd b (SF) (AF) . The scale correctio...
متن کاملSimulation of gas-liquid two phase flow in upriser pipe of gas-lift systems
Gas-lift pumps are devices for lifting liquid phase incorporating the gas phase to be injected in the bottom of liquid column. They are widely used in various industrial applications such as oil extracting in petroleum industries. Gas-liquid flow being the main part of the flow through these systems, flowing in vertical pipes of gas-lift pumps has different regimes namely bubbly, slug, chur...
متن کاملMulti-fluid model applied to calculate backmixing and mass transfer in bubble columns
For the calculation of reactive flows in bubble columns the local interfacial area is one of the key parameters. In addition backmixing causes a residence time distribution in the gas and liquid phase, thus mixing phenomena have to be considered as well. The three-dimensional, instationary flow fields in bubble columns are numerically calculated using an Euler multi-fluid model. The resulting s...
متن کامل