Examining crystallographic orientation dependence of hardness of silica stishovite

We conducted nanoindentation to explore the hardness and elastic properties of silica stishovite, synthesized at high pressure and quenched to ambient conditions. A total of 10 crystallographic orientations were examined on selected grains with a maximum load of 4 or 20mN. We observed discontinuity in the load–displacement curve (pop-in) for the 1⁄22 5 1̄ and 1⁄26 2 1̄ grains subjected to a maximum load of 20mN. The single-crystal hardness at high plastic deformation is quasi-isotropic with an average of 32 1GPa, similar to the polycrystalline hardness reported earlier; the theoretical hardness determined from the experiments is about 54 3GPa. These two hardnesses suggest that stishovite is one of the hardest oxides. The measured indentation moduli are close to the predictions at low load (minor plasticity) but are considerably lower at high load (high plasticity). Both indentation hardness and modulus decrease with increasing plasticity. Our results underscore the necessity of considering the degree of plastic deformation when interpreting hardness and elastic moduli from indentation experiments. r 2007 Elsevier B.V. All rights reserved. PACS: 62.20. x; 62.20.Qp; 91.60.Dc