Design of Low-Power and High-Speed Opamp Integrated Circuits Using Silicon Nanowire Transistors
نویسندگان
چکیده
SNTs (surrounding-gate nanowire transistors) are good candidates to implement low power electronic devices. They provide full gate control over the channel and minimize short channel effects. Design of a high-speed opamp is presented in this paper. It consists of two amplifying stages and an output buffer and is frequency compensated for stable operation. Transistors used have 10nm channel length and 2nm channel radius. The amplifier operates from 1.8V supply and has a voltage gain of 40dB and a phase margin of 42°. The current gain cutoff frequency of the amplifier is 5.1THz and it provides 40dB common mode rejection ratio and 54dB power supply rejection ratio with a slew-rate of 2V/ns. The amplifier area is 320nm by 250nm.
منابع مشابه
Design and Implementation of MOSFET Circuits and CNTFET, Ternary Multiplier in the Field of Galois
Due to the high density and the low consumption power in the digital integrated circuits, mostly technology of CMOS is used. During the past times, the Metal oxide silicon field effect transistors (MOSFET) had been used for the design and implementation of the digital integrated circuits because they are compact and also they have the less consumption power and delay to the other transistors. B...
متن کاملDesign and Implementation of MOSFET Circuits and CNTFET, Ternary Multiplier in the Field of Galois
Due to the high density and the low consumption power in the digital integrated circuits, mostly technology of CMOS is used. During the past times, the Metal oxide silicon field effect transistors (MOSFET) had been used for the design and implementation of the digital integrated circuits because they are compact and also they have the less consumption power and delay to the other transistors. B...
متن کاملSymmetrical, Low-Power, and High-Speed 1-Bit Full Adder Cells Using 32nm Carbon Nanotube Field-effect Transistors Technology (TECHNICAL NOTE)
Carbon nanotube field-effect transistors (CNFETs) are a promising candidate to replace conventional metal oxide field-effect transistors (MOSFETs) in the time to come. They have considerable characteristics such as low power consumption and high switching speed. Full adder cell is the main part of the most digital systems as it is building block of subtracter, multiplier, compressor, and other ...
متن کاملA Switched Opamp Comparator to Improve the Conversion Rate of Low-Power Low-Voltage Successive Approximation ADCs
The continued drive toward technology scaling in VLSI design has provided greater integration levels in silicon chips. Thanks to the reduction in minimum feature size and the corresponding decrease in power supply voltage, digital circuits have benefited from savings in area and power consumption. This approach presents a number of challenges in Complementary Metal-Oxide Semiconductor (CMOS) an...
متن کاملHigh-Speed Ternary Half adder based on GNRFET
Superior electronic properties of graphene make it a substitute candidate for beyond-CMOSnanoelectronics in electronic devices such as the field-effect transistors (FETs), tunnel barriers, andquantum dots. The armchair-edge graphene nanoribbons (AGNRs), which have semiconductor behavior,are used to design the digital circuits. This paper presents a new design of ternary half a...
متن کامل