Overview and Analysis of UWB signal for Low Power WPAN
نویسندگان
چکیده
In modern short range wireless applications, RF, Bluetooth and UWB communication schemes are recommended with respect to power consumption, low/high data rates and location capability. Though special bandwidth is not allocated to UWB, coexistence of such signal in the available RF environment is a critical issue and hence analysis of UWB signal with respect to interference is very much required in dedicated WPAN networks. In this paper, effect of UWB interference for existing systems such as GPS, FWA, UMTS, DCS1800 is analyzed. Communication path distance is directly proportional to the UWB signal pulse width. To correctly define the UWB signal this functionality is realized by composing UWB signal and results are simulated using MATLAB.
منابع مشابه
LR-WPAN and UWB data communication systems: A new possible application for chaotic carriers
Radio communications via channels already occupied by conventional telecommunication systems can be established only by Ultra-WideBand (UWB) radio where the spectrum of transmitted signal covers an ultra-wide frequency band. The power spectral density (psd) of transmitted UWB signal is extremely low and does not cause any noticeable interference in the conventional telecommunication systems. Th...
متن کاملیک روش جستجوی دو- مرحلهای برای همزمانی سریع سیستمهای باند فوق وسیع در محیطهای چندمسیره
Ultra-wideband (UWB) radio is a promising technology for low-cost, high-rate communications at short ranges. However, high bandwidth and low power of the UWB signals impose some difficult challenges in signal processing and implementation of the receiver. Acquisition of the signal timing is the first task to be performed in a coherent receiver. The high bandwidth of UWB signals demand for fine ...
متن کاملDynamic Channel Scheduling for UWB-Based WPAN
Wireless Personal Area Network (WPAN) has gained a lot of attention in industry recently. UltraWideband (UWB) presents itself as a good alternative physical layer of WPAN, for both high and low data rate applications. Here, we present an algorithm that can utilize the available channels in UWB systems. The algorithm is known as Dynamic Channel Scheduling Algorithm (DCSA). The proposed algorithm...
متن کاملA Broadband Low Power CMOS LNA for 3.1–10.6 GHz UWB Receivers
A new approach for designing an ultra wideband (UWB) CMOS low noise amplifier (LNA) is presented. The aim of this design is to achieve a low noise figure, reasonable power gain and low power consumption in 3.1-10.6 GHz. Also, the figure of merit (FOM) is significantly improved at 180nm technology compared to the other state-of-the-art designs. Improved π-network and T-network are used to obt...
متن کاملPerformance enhancement of UWB power control using ranging and narrowband interference mitigation
Power control is a critical parameter for the design and evaluation of UWB-based WPAN networks due to its distributed control nature and non-fixed topology. The main issues in UWB PC are the channel gain fluctuations induced by indoor channel fluctuation and interference arising from narrowband systems. In this paper we introduce a joint PHY/MAC technique for DS-UWB power control design by expl...
متن کامل