[Comparative study of microleakage in class V restorations].

نویسندگان

  • Débora Gonçalves de Farias
  • Rander Pereira Avelar
  • Ana Cristina Barreto Bezerra
چکیده

The aim of this study was to analyze the laboratorial performance of dentin-bonding agents, glass ionomer cements and compomers, regarding the sealing of the gingival margins of class V cavities, prepared on the cementoenamel junction. Standardized class V cavities (4 x 3 x 2 mm) were prepared on the buccal and lingual/palatal surfaces of 20 extracted human third molars. Forty cavities were restored with different combinations of materials, as follows: group 1 (G1)--Vitremer (3M); group 2 (G2)--Vitremer (3M) and Syntac Sprint/Tetric Ceram (Vivadent); Group 3 (G3)--Syntac Sprint/Tetric Ceram (Vivadent); Group 4 (G4)--Prime & Bond 2.1/Variglass (Dentsply). After thermocycling in methylene blue dye, the specimens were longitudinally sectioned and analyzed with a stereoscopic lens in order to evaluate the leakage on the gingival margin. The obtained data were analyzed with the Mann-Whitney test, and the results revealed significantly better sealing (p = 0.05) in G1, when compared with G4. No significant differences were seen between the other groups. Under the given conditions, Vitremer offered better sealing of the gingival margin than the system Prime & Bond 2.1/Variglass.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Comparative evaluation of microleakage of composite restorations using fifth and seventh generations of adhesive systems

Introduction: Simultaneous etching of enamel and dentin using the novel generation of adhesive systems with contracted operational steps, has shown a good clinical efficacy. The aim of this study was to evaluate the microleakage of composite restorations using the V and VII generations of adhesive systems on primary teeth. Methods: This study was performed on 45 human intact extracted primar...

متن کامل

The Effect of Dental Bonding Agent of Excite on the Rate of Microleakage in Class V Amalgam Restorations

Aim: This study was done to evaluate the rate of microleakage in class V amalgam restorations in which the dental bonding agent (DBA) Excite was used as a sealer beneath the restorations. Methods: four amalgam restorative materials with commercial names of Dentam, Cinalux, Tytin and SDI (GS-80) were used. Seventy sound human premolars were selected and randomly divided into 4 groups of 15 teeth...

متن کامل

Microleakage comparison of three types of adhesive systems versus GIC-based adhesive in class V composite restorations

Background and aims: New dentin bonding agents and techniques have been developed to reduce microleakage and create higher bond strength. This in-vitro study compared the microleakage of three resin-based adhesives versus a GIC-based adhesive on class V composite restorations.  Materials and Methods: Class V cavities were prepared on the buccal surfaces of 72 sound premolars, randomly assigned ...

متن کامل

The Effect of Different Periods of Enamel Microabrasion on the Microleakage of Class V Glass-Ionomer Restorations

Objective: Removal of enamel superficial layer during microabrasion treatments may adversely affect sealing ability of the restorative materials. The aim of this study was to measure the effect of different periods of enamel microabrasion on the microleakage of class V glass-ionomer restorations. Methods: This in vitro experimental study was conducted on 96 Class V cavities which had been pr...

متن کامل

Effect of Three Light Curing Protocols and Load Cycling on Microleakage of Class V Composite Restorations

  Objective: Different methods have been suggested to overcome the polymerization shrinkage of composite restorations. Changing the light curing protocol to improve polymerization by using new light curing units is among these methods. The new devices are more efficient, portable and durable and produce less heat. This study aimed to assess the marginal microleakage of class V composite restora...

متن کامل

The effect of three different curing methods on the microleakage of cl V posterior composite restorations

The effect of three different curing methods on the microleakage of cl V posterior composite restorations Dr. N. Mohammadi* - Dr. P. Alizadeh Oskoee* - Dr. S. Savadi Oskoee*- Dr. A . Soleyman zadeh** *- Assistant Professor of Esthetic & Operative Dentistry Dept. - Faculty of Dentistry – Tabriz University of Medical Sciences.*- Dentist. Background and Aim: Light-cured composites have become almo...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • Pesquisa odontologica brasileira = Brazilian oral research

دوره 16 1  شماره 

صفحات  -

تاریخ انتشار 2002