Kobayashi - 1 - DEVELOPMENT OF A FINITE ELEMENT MODEL OF THE HUMAN NECK FOR WHIPLASH SIMULATION
نویسندگان
چکیده
A finite element model of the human neck that consists of the vertebral bodies, internal discs, ligaments and muscles has been developed in this study. Not only representing the precise geometry of the human body parts, this study also focused on the muscular response during impacts. A spring-dashpot model has been introduced to activate muscle elements in the head-neck-thorax complex. The evaluation process of the model was divided into two steps. In the first step, the head responses of the neck model were examined while the input was given to the T1 motion and some other connecting points. The complete upper body motion was simulated in the second step by modeling a seat system mounted on a sled. The simulation results showed good agreement with the experimental data and suggested that the model well simulates the head and neck kinematics and responses.
منابع مشابه
Development of a Finite Element Model of the Human Neck for Whiplash Simulation
A finite element model of the human neck that consists of the vertebral bodies, internal discs, ligaments and muscles has been developed in this study. Not only representing the precise geometry of the human body parts, this study also focused on the muscular response during impacts. A spring-dashpot model has been introduced to activate muscle elements in the head-neck-thorax complex. The eval...
متن کاملProposing a 2D Dynamical Model for Investigating the parameters Affecting Whiplash Injuries
This paper proposes a 2D dynamical model for evaluating parameters affecting whiplash. In fact a four segment dynamical model is developed in the sagittal plane for the analysis. The model response is validated using the existing experimental data and is shown to simulate the "S-Shape" and "initial upward ramping" kinematics of the cervical spine and the resulting dynamics observed in human and...
متن کاملFinite element simulation of the clinching process of steel sheets and study on influence of anisotropy on the mechanical behavior of joint
This article describes a numerical study on the TOX-clinching process of the steel sheets. In addition, the influence of plastic anisotropy of the material on joining parameters is analyzed by evolution of the joint parameters such as undercut and neck thickness and punch force-displacement curve. Finite element analysis with ABAQUS/CAE-Explicit program is used to simulate two dimensional and t...
متن کاملQuantitative Comparison of Analytical solution and Finite Element Method for investigation of Near-Infrared Light Propagation in Brain Tissue Model
Introduction: Functional Near-Infrared Spectroscopy (fNIRS) is an imaging method in which light source and detector are installed on the head; consequently, re-emission of light from human skin contains information about cerebral hemodynamic alteration. The spatial probability distribution profile of photons penetrating tissue at a source spot, scattering into the tissue, and being released at ...
متن کاملSimulation and Experimental Study of Vibration and Noise of Pure Electric Bus Transmission based on Finite Element and Boundary Element Methods
Since the electric motor of pure electric vehicle replaced the engine, the "masking effect" disappears, and the problem of vibration and noise of the transmission becomes prominent. This is generated during the gear meshing and is transmitted to the housing through the shaft and bearing. Thereby, radiation noise of the housing are generated. The prediction and analysis...
متن کامل