The Influence of Drawing Speed on Structure Changes in High Carbon Steel Wires
نویسنده
چکیده
M. Suliga, R. Kruzel, T. Garstka, Czestochowa University of Technology, Czestochowa, Poland J. Gazdowicz Institute of Ferrous Metallurgy Gliwice, Poland In the paper the influence of the drawing speed on structure changes has been assessed. The Scanning Electron Microscope investigation confirmed that for wires drawn with high total draft, exceeding 80 %, makes it impossible to clearly assess the impact of drawing technology on structural changes in the drawn wires. Thus, to assess the structural changes necessary to apply quantitative methods. On the basis of examination of the wire structure by measuring of electrical resistance, the structure changes in drawn wires has been determined. It has been shown that the increase of drawing speed, especially above 15 m/s, causes an increase in structure defect, with a decline in platelet orientation of cementite in drawn wires.
منابع مشابه
Developing Very Fine Nanopearlitic Structure in a High Carbon Steel Wire before Drawing
The effects of steel wire patenting process parameters on very fine interlamellar spacing in the pearlitic steel wire were investigated and the optimized condition of the process was achieved. In this work, the initial nanopearlitic structure was obtained in a 0.72 wt% carbon steel wire before the wire drawing process. The results were the minimum interlamellar spacing of 35 nm and maximum ulti...
متن کاملStatic Strain Aging Behavior of Low Carbon Steel Drawn Wire
The static strain aging is a phenomenon that can change the mechanical properties of low carbon steels. Thus, the static strain aging behavior of low carbon steel wires after drawing process is studied. To do so, the wires are austenitized at different temperatures and cooled in different rates. Then the wires are drawn and aged at a specific temperature and time. Before and after aging of each...
متن کاملRecrystallization Behavior of Deep Drawing Low Carbon Steel Sheets Produced by Mobarakeh Steel Plant
In the present work the recrystallization behavior of deep drawing grade Al-killed low carbon steel sheets produced by Mobarakeh Steel Plant (MSP) has been studied. Salt bath isothermal annealing has b...
متن کاملFem Analysis of Effect of Die Angle on Strain and Stress State in Process of Drawing of Steel for Prestressed Concrete
A die angle is one of the most important parameters for a drawing process. It should be chosen in that way that a draw stress is low, a wire surface quality is satisfactory and die durability is high [1]. The temperature of a wire in deformation zone depends on amounts of heat generated during a drawing. This heat consists of two components; one is the work piece deformation and another is fric...
متن کاملThe Mechanical Properties of High Carbon Steel Wires Drawn in Conventional and Hydrodynamic Dies
M. Suliga, R. Kruzel, Czestochowa University of Technology, Czestochowa, Poland In the paper the infl uence of the hydrodynamic die on mechanical properties has been assessed. The drawing process of φ 5,5 mm wires to the fi nal wire of φ 2,5 mm was conducted in 7 passes, in industrial conditions, by means of a modern Koch multi-die drawing machine. The drawing speed in the last passes was 8,2 m...
متن کامل