Analysis of Shear Deformation Scheme Efficiency in Plastic Structure Formation Processes
نویسندگان
چکیده
G. I. Raab, A. G. Raab, Ufa State Aviation Technical University, Ufa, Russia V. G. Shibakov, Kazan Federal University, Kazan, Russia The paper is devoted to the analysis of such an important factor as deformation behavior in the simple shear conditions. It is shown that non-monotonous character of material plastic flow exerts significant influence on the intensity of initial structure refinement. Induced non-monotonous character that ensures formation of equiaxed structural states plays an important role in the process.
منابع مشابه
Review on ultrafined/nanostructured magnesium alloys produced through severe plastic deformation: microstructures
A review on the microstructural evolution in magnesium alloys during severe plastic deformation waspresented. The challenges deserved to achieve ultrafine/ nanostructured magnesium were discussed.The characteristics of the processed materials are influenced by three main factors, including i)difficult processing at low temperatures, ii) high temperature processing and the occurrence ofdynamic r...
متن کاملFinite Element Analysis of Functionally Graded Skew Plates in Thermal Environment based on the New Third-order Shear Deformation Theory
Functionally graded materials are commonly used in thermal environment to change the properties of constituent materials. The new numerical procedure of functionally graded skew plates in thermal environment is presented in this study based on the C0-form of the novel third-order shear deformation theory. Without the shear correction factor, this theory is also taking the desirable properties a...
متن کاملDynamics of nonlinear rectangular plates subjected to an orbiting mass based on shear deformation plate theory
In this paper, transverse and longitudinal vibration of nonlinear plate under exciting of orbiting mass is considered based on first-order shear deformation theory. The nonlinear governing equation of motion are discretized by the finite element method in combination with Newmark’s time integration scheme under von Karman strain-displacement assumptions. For validation of method and formulation...
متن کاملSuperplasticity of a fine-grained Mg–1.5 wt% Gd alloy after severe plastic deformation
The strain rate sensitivity (SRS) of Mg–1.5 wt% Gd processed by conventional extrusion and 2 passes of simple shear extrusion (SSE) was investigated by shear punch testing. Shear punch tests were conducted at initial shear strain rates in the range of 0.003–0.3 s-1 and at temperatures in the range of 573–773 K. A fine-grained microstructure with an average grain size of about 2.5 µm, obtained a...
متن کاملImproving Mechanical Properties, Especially Increasing Tubes’ Strength by Micro structuring Metals Using Severe Plastic Deformation Method
Increasing material’s strength is of particular importance. Improving material’s mechanical properties such as strength could reduce the size and weight of the structure. The size and weight of the structure are among the effective parameters in design. Since the past a variety of methods have been developed to increase the strength of metals that are capable of increasing metals’ strength to a...
متن کامل