Chapter 3 Solution of Fission Products in
نویسنده
چکیده
UO2 is the standard nuclear fuel used in modern, conventional power reactors (e.g. PWR, BWR and AGR). The oxide phase of fissile uranium provides the necessary thermodynamic stability required in operating conditions. It then follows that an extensive knowledge of the properties of this material is necessary. Unfortunately, experimental research is costly, especially if fission products are considered. Therefore, computer simulation is a desirable alternative. In this chapter, an attempt is
منابع مشابه
توزیع بار الکتریکی محصولات شکافت حاصل از واکنش شکافت اورانیم 238 با پروتونهای 45-69 MeV
Fission of 238U nuclei was performed by 45-69 MeV protons at the Cyclotron and Radioisotope Center of Tohoku University in Japan. The fission products originated in the reaction were identified by using gamma spectroscopy. The experimental data show that the charge distribution of isobar fission products follows a Gaussian distribution with a standard deviation independent of the selected mass...
متن کاملگذر از شکافت نامتقارن به متقارن در واکنش شکافت اورانیم 238 با پروتونهای MeV 69 - 45
Thin targets of 238U were bombarded with 45, 55, 65 and 69 MeV protons at the Cyclotron and Radioisotope Center (CYRIC) of Tohoku University in Japan. Gamma rays emitted from the fission products were recorded and analyzed by using gamma spectroscopy. Then, the cross sections for the formation of fission products, fragment mass distributions, and total fission cross sections were measured. Spec...
متن کاملA genetic algorithm-based approach for numerical solution of droplet status after Coulomb fission using the energy
As a droplet moves, due to evaporation at the surface, the droplet size is gradually reduced. Due to decreasing the size of the droplets moving in the spray core, the surface charges become closer and the repulsive force between the charges increases. When the Coulombic force overcomes the surface tension force (Rayleigh instability) the droplet breaks into smaller droplets (Coulomb fission). T...
متن کاملComputing Atomic Density Changes of Material Composition in Operation of the Nuclear Reactor Core
The present work investigates an appropriate way to calculate the 1700 atomic density changes in the reactor operations. To automate this procedure, a computer program has been designed by C#. This program suggests a way to solve this problem which is based on the solution system of differential equations (Bitman) that it is designed according to Runge-Kutta Fehlberg method. The designed softwa...
متن کاملThe Study of Nonlinear Dynamical Systems Nuclear Fission Using Hurwitz Criterion
In this paper, the nonlinear dynamic system of equations, a type of nuclear ssion reactor is solved analytically and numerically. Considering that the direct solution of three-dimensional dynamical systems analysis and more in order to determine the stability and instability, in terms of algebraicsystems is dicult. Using certain situations in mathematics called Hurwitz criterion, Necessary and ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2003