Friction in full view
نویسندگان
چکیده
The authors report the direct observation of a single asperity tungsten tip sliding on graphite by in situ transmission electron microscopy TEM nanomanipulation. The in situ TEM studies have confirmed that graphitic flakes transfer to a sliding tungsten probe, validating proposed friction mechanisms explaining the unique tribological properties of graphite. Wear of graphite was observed, typically removing sheets of graphite on the order of ten basal planes in thickness. Consistency between wear flake thickness and interfacial dislocation standoff distances is discussed. © 2007 American Institute of Physics. DOI: 10.1063/1.2456192
منابع مشابه
Dry Friction and Wear Performance of Micro Surface Textures Generated by Ultrasonic Assisted Face Turning
Nowadays the surface texturing has been widely recognized as a usable capability to improve the tribological systems. In this paper, ultrasonic assisted turning (UAT) isperformed to create the micro textures on the flat faces. Micro surface texturing ismade on the Al7075-T6 by the UAT in the face turning process. Then, the influences of cutting speed feed, vibration direction and vibration ampl...
متن کاملInstability prediction of a fully updated brake system with uncertainty in contact conditions
Brake squeal, as friction-induced audible noise above 1 kHz to 20 kHz, is a major concern to automotive manufacturers because of noise, vibration and harshness performance and warranty-claim related costs. The prediction of brake squeal is as difficult as ever due to nonlinearities, uncertainty boundary and operating conditions. The exact contact conditions between pad linings with rotor are of...
متن کاملDry Friction and Wear Performance of Micro Surface Textures Generated by Ultrasonic Assisted Face Turning
Nowadays the surface texturing has been widely recognized as a usable capability to improve the tribological systems. In this paper, ultrasonic assisted turning (UAT) isperformed to create the micro textures on the flat faces. Micro surface texturing ismade on the Al7075-T6 by the UAT in the face turning process. Then, the influences of cutting speed feed, vibration direction and vibration ampl...
متن کاملNon-Equilibrium Thermodynamical Framework for Rate- and State-Dependent Friction
Rateand state-dependent friction laws for velocity-step and healing are analysed from a thermodynamic point of view. Assuming a logarithmic deviation from steady-state, a unification of the classical Dieterich and Ruina models of rock friction is proposed.
متن کاملA Case Typical of Rural Midwifery Practice
me in labour at 10 p.m. on the 19th July 1926 at her house in an adjoining village in response to a 'hurried and urgent call. Her history was that she had completed full term, had had no illness during pregnancy, and that she had commenced to feel weak pains thirtytwo hours previously. Her abdomen had been massaged by friends and two hours later a foetal hand prolapsed and appeared. Her female ...
متن کامل