Stability of Microstructures for Some Martensitic Transformations
نویسنده
چکیده
We analyze the stability of laminated microstructure for martensitic crystals that undergo cubic to trigonal, orthorhombic to triclinic, and trigonal to monoclinic transformations. We show that the microstructure is unique and stable for all laminates except when the lattice parameters satisfy certain identities.
منابع مشابه
The effect of deep cryogenic treatment on mechanical properties of 80CrMo12 5 tool steel
Cryogenic treatment can be used as a supplemental treatment that is performed on some tool steels between quenching and tempering as an effective method for decreasing retained austenite and increasing wear resistance. In this research, the effect of deep cryogenic treatment (DCT) on dimensional stability and mechanical properties of 80CrMo12 5 tool steel was investigated. The martensitic trans...
متن کاملSymmetry and reversibility of martensitic transformations
Martensitic transformations are diffusionless solid-to-solid phase transformations characterized by a rapid change of crystal structure, observed in metals, alloys, ceramics, and proteins. They come in two widely different classes. In steels, the transformation microstructure induced by quenching remains essentially unchanged upon subsequent loading or heating; the transformation is not reversi...
متن کاملEffect of the Primary Microstructures during Training Producers on TWSME in NiTi Alloys (TECHNICAL NOTE)
The influence of the martensitic, martensitic+austenitic and austenitic structures in bending training on two-way shape memory effect (TWSME) in Ni-50.8 at %Ti and Ni-49.9 at %Ti alloys was studied. In addition of the primary structure, the effect of pre-strain, plastic strain, training cycle and training temperature on the TWSME was investigated. The prepared samples were trained in martensiti...
متن کاملStability of microstructure for tetragonal to monoclinic martensitic transformations
We give an analysis of the stability and uniqueness of the simply laminated microstructure for all three tetragonal to monoclinic martensitic transformations. The energy density for tetragonal to monoclinic transformations has four rotationally invariant wells since the transformation has four variants. One of these tetragonal to monoclinic martensitic transformations corresponds to the shearin...
متن کاملThe e&ective energy and laminated microstructures in martensitic phase transformations
We study the behavior of crystals that undergo martensitic transformations. On cooling, the high-temperature phase (austenite) transforms to the martensite phase changing its crystalline symmetry. The lower crystalline symmetry of the martensite gives rise to several variants of martensite. Each variant has an associated transformation strain. These variants accommodate themselves (according to...
متن کامل