Dimensional stability of two solder index materials

OBJECTIVES This study aimed to compare the dimensional accuracy of two indexing materials, an acrylic resin (GC pattern resin) and a castable composite (Bredent). The effect of time lapse until investment was also investigated. MATERIALS AND METHODS Two standardized brass dies 15 mm apart were prepared and then 20 identical coping-bar assemblies were designed and fabricated by a rapid prototyping device. Each bar was sectioned at the center, and indices were fabricated from an acrylic resin or castable composite (n = 10 per group). The distances between the reference points were measured with a digital microscope at ×80 magnifications at 15 min, 60 min, and 24 h after indexing. Data were statically analyzed using repeated-measure ANOVA (α = 0.05). RESULTS The distance between the reference points without the coping being joined was considered as the baseline measurement (control group). The mean distance was 19.30 ± 0.04 mm between the reference points where the copings were not joined. When indexed with acrylic resin, the mean ± standard deviation (SD) dimensions were 19.27 ± 0.087 mm (15 min), 19.25 ± 0.09 mm (60 min), and 18.98 ± 0.1 mm (24 h). The mean ± SD dimensions for composite were 19.29 ± 0.087 mm (15 min), 19.28 ± 0.08 mm (60 min), and 19.26 ± 0.08 mm (24 h). All tested groups showed significant differences compared to the control group except when it was indexed with composite and where the distances were measured after 15 and 60 min (P > 0.05). CONCLUSIONS The most accurate indexed-assemblies belonged to castable composite at 15 and 60 min.