Cannulated versus non-cannulated cancellous screw fixation for femoral neck fractures: a synthetic bone biomechanical study

Purpose. To compare the compressive strength of cannulated versus non-cannulated cancellous screws for undisplaced femoral neck fractures in synthetic bones. Methods. 18 synthetic proximal femurs simulating an AO B1 valgus impacted femoral neck fracture in osteoporotic bone were used. The fracture angles were between 55o and 63o (Pauwels grade 2). Fixation was made using 6.5-mm non-cannulated screws (n=6), 6.5-mm cannulated screws (n=6), or 7.3-mm cannulated screws (n=6). A custom-built jig was designed to guide the insertion of the screws in an identical triangular configuration. Screws were tightened by a single operator using a torquemeasuring screwdriver. The femoral head was subjected to progressive axial loading at 5 mm/min. The load to failure and displacement were recorded. Results. The 3 groups did not differ significantly except that the load to failure was higher in the construct with 6.5-mm non-cannulated screws than Cannulated versus non-cannulated cancellous screw fixation for femoral neck fractures: a synthetic bone biomechanical study AW Gardner,1 MZ Toh,2 KSA Yew,3 DTT Lie,3 SM Chou2 1 Department of Orthopaedic Surgery, Jurong Health Services, Alexandra Hospital, Singapore 2 School of Mechanical and Aerospace Engineering, Nanyang Technological University, Singapore 3 Department of Orthopaedic Surgery, Singapore General Hospital, Singapore Address correspondence and reprint requests to: AW Gardner, Department of Orthopaedic Surgery, Jurong Health Services, Alexandra Hospital, Singapore. Email: [email protected] Journal of Orthopaedic Surgery 2015;23(1):41-6 that with 6.5-mm cannulated screws (1222 N vs 1008 N, p=0.003). Conclusion. The compressive strength of a synthetic bone hip fracture model fixed with non-cannulated screws was higher than that of cannulated screws of the same diameter.