Adiabatic shear instability based mechanism for particles/substrate bonding in the cold-gas dynamic-spray process
نویسنده
چکیده
Particles/substrate interactions during the cold-gas dynamic-spray deposition process are studied using a dynamic axisymmetric thermo-mechanical finite element analysis. In addition, the particles/substrate bonding mechanism has been investigated using a one-dimensional thermo-mechanical model for adiabatic strain softening and the accompanying adiabatic shear localization. The results obtained show that the minimal impact particles velocity needed to produce shear localization at the particles/substrate interface correlates quite well with the critical velocity for particles deposition by the cold-gas dynamic-spray process in a number of metallic materials. This finding suggests that the onset of adiabatic shear instability in the particles/substrate interfacial region plays an important role in promoting particle/substrate adhesion and, thus, particles/substrate bonding during the cold-gas dynamic-spray process. 2004 Elsevier Ltd. All rights reserved.
منابع مشابه
Simulation of Cold Spray Nozzle Accompanying a Water-cooling Adjustment
Cold spraying is a coating process which enables production of metallic and metallic ceramic coatings with dense (very low porosity level) and pure (low oxygen content) structures. Several coating applications such as corrosion resistance and electrical conductivity rely on these properties. Generally, cold spraying is based on higher particle velocities and lower process temperatures than othe...
متن کاملCold spray modeling: An analytical method for predicting bulk properties of cold spray deposits
In the drive towards improved electrical energy storage for applications ranging from electric vehicles to grid stabilization and renewable energy storage, the important role and great need of electrochemical storage and batteries specifically will continue, due to batteries’ high energy density, simplicity, reliability, and potential for favorable performance/cost ratio. A redox flow battery c...
متن کاملTHE EFFECTS OF PLASMA SPRAY PARAMETERS ON THE MICROSTRUCTURE AND PHASE COMPOSITION OF THERMAL BARRIER COATINGS MADE BY SPPS PROCESS
In this paper the effect of plasma spray parameters, atomizing gas and substrate preheat temperature on microstructure and phase composition of YSZ coatings produced by SPPS process have been investigated. The experimental results showed that increasing the power of plasma, using hydrogen as the precursor atomizing gas and increasing substrate preheat temperature decrease the amount of non-pyro...
متن کاملInvestigation of the mechanical properties of cold roll welded Brass and IF steelproduced by cold roll bonding process
Cold roll bonding (CRB) is a solid state welding process, where the bonding is established by compressive plastic deformation of the metals. This process is applicable for a large number of materials. In addition, materials that cannot be bonded by traditional fusion-based processesmight be bonded by CRB process. In this research, cold roll welding of brass and IF steel was studied .The effects...
متن کاملInvestigation of the mechanical properties of cold roll welded Brass and IF steelproduced by cold roll bonding process
Cold roll bonding (CRB) is a solid state welding process, where the bonding is established by compressive plastic deformation of the metals. This process is applicable for a large number of materials. In addition, materials that cannot be bonded by traditional fusion-based processesmight be bonded by CRB process. In this research, cold roll welding of brass and IF steel was studied .The effects...
متن کامل