Surface roughness in rotary ultrasonic machining: hypotheses and their testing via experiments and simulations
نویسندگان
چکیده
Rotary ultrasonic machining (RUM) is a nontraditional drilling process. It has been used to drill not only brittle but also ductile materials. It was observed that the surface roughness of the drilled hole near the entrance side was better than that near the exit side. However, explanations about this observation could not be found in the literature. This paper aims to provide explanations about this observation. It presents three hypotheses and their testing via experiments and simulations.
منابع مشابه
Mechanical Surface Treatments of Ti-6Al-4V Miniplate Implant Manufactured by Electrical Discharge Machining (TECHNICAL NOTE)
Present work aims at multi-mechanical surface treatment of Ti-6Al-4V based-miniplate implant manufactured by electrical discharge machining (EDM) for biomedical use. Mechanical surface treatment consists of consequent use of ultrasonic cleaning, rotary tumbler polishing, and brushing. Surface layers are analyzed employing scanning electron microscopy and energy dispersive X-ray spectroscopy. Al...
متن کاملRotary ultrasonic machining of ceramics: design of experiments
Rotary ultrasonic machining is one of the nontraditional machining processes for advanced ceramics. Currently available in literature are publications on theoretical and experimental studies on material removal rates in rotary ultrasonic machining. However, there is no report on the systematic study of the cutting force in rotary ultrasonic machining. Furthermore, the effects of some process pa...
متن کاملParameters Optimization of Rotary Ultrasonic Machining of Glass Lens for Surface Roughness Using Statistical Taguchi’s Experimental Design
An experiment was conducted to compare the effects of ultrasonic and non-ultrasonic on glass lens using rotary ultrasonic machining (RUM) technology. The primary objective of this study is to analyze the experimental results of the grinding operations using Taguchi method. Feed rate and frequency are the main process parameters to be tested in this experiment. A three-level orthogonal array tab...
متن کاملStudy on Edge Chipping in Rotary Ultrasonic Machining of Ceramics: An Integration of Designed Experiments and Finite Element Method Analysis
Rotary ultrasonic machining (RUM) is a relatively low cost and environmentally benign process for machining of advanced ceramics. Much effort has been made to theoretically and experimentally investigate material removal rate, surface roughness, and tool wear in RUM. However, there is no report on systematic study of edge chipping in RUM drilling of ceramics. This paper presents the results of ...
متن کاملRotary ultrasonic machining of silicon carbide: designed experiments
Silicon carbide (SiC) has found a variety of engineering applications due to its superior properties. However, it is still desirable to study cost-effective processes to machine silicon carbide. This paper presents the results of a designed experimental investigation into Rotary Ultrasonic Machining (RUM) of silicon carbide. A four-variable two-level full factorial design was employed to reveal...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- IJMR
دوره 8 شماره
صفحات -
تاریخ انتشار 2013