Properties of Carry Value Transformation

نویسندگان

  • Suryakanta Pal
  • Sudhakar Sahoo
  • Birendra Kumar Nayak
چکیده

-The notion of Carry Value Transformation (CVT) is a model of Discrete Deterministic Dynamical System. In this paper, we have studied some interesting properties of CVT and proved that (1) the addition of any two non-negative integers is same as the sum of their CVT and XOR values. (2) While performing the repeated addition of CVT and XOR of two non-negative integers “a” and “b” (where a ≥ b), the number of iterations required to get either CVT=0 or XOR=0 is at most the length of “a” when both are expressed as binary strings. A similar process of addition of Modified Carry Value Transformation (MCVT) and XOR requires a maximum of two iterations for MCVT to be zero. (3) An equivalence relation is defined in the set Z Z × which divides the CV table into disjoint equivalence classes.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Theory of Carry Value Transformation (CVT) and its Application in Fractal formation

In this paper the theory of Carry Value Transformation (CVT) is designed and developed on a pair of n-bit strings and is used to produce many interesting patterns. One of them is found to be a self-similar fractal whose dimension is same as the dimension of the Sierpinski triangle. Different construction procedures like L-system, Cellular Automata rule, Tilling for this fractal are obtained whi...

متن کامل

Effect of Mechanical Alloying and Sintering on Phase Transformation, Microstructural Evolution, Mechanical Properties and Density of Zr-Cr Alloy

The purpose of present research was production ofZr-based alloy as the nuclear fuel cladding by mechanical alloying (MA) and sintering process. Firstly, Zr and Cr powders were mechanically alloyed to produce the refractory and hard Zr-10 wt% Cr alloy, and then, the powder mixtures were consolidated by press and following sintering at temperature of 800˚C min. The phase evolution, microstructura...

متن کامل

Solution of Troesche's problem by double exponential Sinc collocation method

In this investigation, the Sinc collocation method based on double exponential transformation is developed to solve the Troesche's problem. Properties of this method are utilized to reduce the system of strongly nonlinear two point boundary value problem to same nonlinear algebraic equations. Combining double exponential transformation through Sinc collocation method causes the remarkable resul...

متن کامل

Study of Variation of the J-integral and the Fracture Toughness in Blunt V-notches under Mode I Loading

Fracture assessment of U- and V-notches is important in mechanical engineering. One can use the J-integral as fracture parameter in order to predict the critical fracture load in notches. The critical value of the J-integral in cracks is a function of the material properties. In notches, however, the material properties as well as the notch dimensions affect this critical value (named fracture ...

متن کامل

The effects of chemical composition variations on microstructure and mechanical properties of nanostructured, low temperature bainitic steels

Bainitic transformation at low transformation temperatures leads to a microstructure involving fine plates of bainitic ferrite and thin films of retained austenite. This microstructure has shown ultimate tensile strength of about 2.2 GPa, noticeable uniform elongation in the range of 5 to 30%, hardness values of about 600 to 670 HV and impact toughness in the range of 30 to 40 MPa m1/2. With ca...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • Int. J. Math. Mathematical Sciences

دوره 2012  شماره 

صفحات  -

تاریخ انتشار 2012