Estimating Cutting Forces in Micromilling by Input Estimation from Closed-Loop Data
نویسنده
چکیده
Estimation of cutting forces in micromilling from the signals of a spindle with Active Magnetic Bearings (AMB) is treated as an input estimation problem. For the closed-loop AMB system, a minimum mean square error input estimator with an adjustable delay is derived. This filter is based on the Wiener filter, where the unknown input is treated as white noise filtered by known dynamics and the controller is assumed to be known. It is shown that controller knowledge can be replaced by a perfect measurement of the control signal. Simulation results demonstrate the applicability of the presented approach.
منابع مشابه
Fuzzy cutting force modelling in micro-milling
Reliable prediction of cutting forces is essential for micromilling. In this paper, a fuzzy cutting force modelling method based on subtractive clustering method filters the noise and estimates the instantaneous cutting forces using observations acquired by sensors during cutting experiments. In the experimental case study, four data sets of micromilling cutting force are used. Each data set is...
متن کاملSIMULATION AND MONITORING OF THE MACHINING PROCESS VIA FUZZY LOGIC AND CUTTING FORCES
On time replacement of a cutting tool with a new one is an important task in Flexible Manufacturing Systems (FMS). A fuzzy logic-based approach was used in the present study to predict and simulate the tool wear progress in turning operation. Cutting parameters and cutting forces were considered as the input and the wear rate was regarded as the output data in the fuzzy logic for construct...
متن کاملInfluence of the Estimation of Cutting Force Coefficients in Micromilling
This paper presents a new model for the estimation of cutting forces in micromilling based on specific cutting pressure. The proposed model includes three parameters which allow to control the entry of the cutter in the workpiece and which consider also the errors in the radial position of the cutting edges of the tool. The presented model is orientated to adaptive control in the micromilling p...
متن کاملAnalysis of the variability of joint input-output estimation methods
It has been recently established that, when estimating parametric models on the basis of closed loop data, the frequency domain variability of direct and various indirect methods may significantly differ from one another. This paper continues this work by analysing the performance of certain common joint input-output estimation methods.
متن کاملPulsed Laser Assisted Micromilling for Die/Mold Manufacturing
Laser assisted machining is an alternative to conventional machining of hard and/or difficult-to-process materials which involves pre-heating of a focused area with a laser beam over the surface of the workpiece to cause localized thermal softening along the path of the cutting action. The main advantage that laser assisted machining has over conventional machining is the increased material rem...
متن کامل