Fault Location Faulty Powers Intelligent Solutions
نویسنده
چکیده
Asian Power February 2002 21 www.asian-power.com Fault management in distribution networks is one of the most challenging and at least the most visible task of the utilities. From the customer point of view the power cut means at least harm but in many cases also costs, which may be tens of times greater than the cost of delivered energy. Pekka Verho, Product Manager at ABB in Finland (part time professor at the Tampere University of Technology) and Pertti Järventausta a professor at the Tampere University of Technology look at the fault management process and an IT-based solution that provides support for this process. Faulty powers
منابع مشابه
Fault Classification in Electric Power Transmission Lines using Support Vector Machine
Transmission lines forms the backbone of the transmission and distribution networks which powers the nation. No modern society can imagine its existence without power supplies which runs everything ranging from consumer electronics to bullet trains. Electrical power systems suffer from unexpected failures due to various random causes. Unpredicted faults that occur in power systems are required ...
متن کاملفاصله یابی خطا در خطوط انتقال نیرو با سه پایانه در حوزه زمان با استفاده از اندازه گیریهای همزمان و مدل گسترده خط انتقال
Conventional fault location methods using voltages and currents of one terminal are not applicable to multiterminal transmission lines. So far some techniques have been presented to solve fault location problem for multi-terminal transmission lines. In these methods, lumped or distributed frequency domain models of transmission lines have been used. In multi terminal lines, faulty section shoul...
متن کاملالگوریتم جامعی برای مکان یابی خطا در خطوط انتقال دو مداره و چند پایانه ای (بیش از سه پایانه) مبتنی بر داده های PMU
A new PMU-based fault detection/location algorithm for multi-terminal transmission lines is proposed in this paper, which works on the basis of synchronized voltage and current phasors received from PMUs installed in various terminals. The Clark transform (for transposed transmission lines), Eigen-values and eigenvectors theory (for un-transposed ones) are used to decouple 3-phase differential ...
متن کاملA Method for Multiple Fault Diagnosis in Analog Circuits
---Fault diagnosis of analog circuits is essential for analog and mixed-signal circuits testing and maintenance. In this paper, a new method for multiple fault diagnosis in linear analog circuits is proposed based on the large change sensitivity analysis and ambiguity group locating technique. Test equation establishes the relationship between the measured responses and deviations of faulty par...
متن کاملOptimal Placement and Sizing of Fault Current Limiter in a Real Network: a Case Study (TECHNICAL NOTE)
In this paper, the effect of number and fault current limiter(FCL) location has been investigated in order to have maximum reduction of short circuit current level in all buses in a real network. To do so, the faulty buses were identified in terms of short circuit current level by computing short circuits on the desired network. Then, while the fault current limit was modeled, its optimal locat...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2002